Maintenance; Specifications - Sony MEX-XB100BT Manual De Instrucciones

Compatible Model
iPod touch
(3rd generation)*
iPod touch
(2nd generation)*
iPod classic*
iPod nano
(7th generation)*
iPod nano
(6th generation)*
iPod nano
(5th generation)*
iPod nano
(4th generation)*
iPod nano
(3rd generation)*
* "SongPal" does not support iPhone 3G, iPod touch
(3rd generation), iPod touch (2nd generation), iPod
classic and iPod nano.
 "Made for iPod," and "Made for iPhone," mean
that an electronic accessory has been designed to
connect specifically to iPod or iPhone,
respectively, and has been certified by the
developer to meet Apple performance standards.
Apple is not responsible for the operation of this
device or its compliance with safety and
regulatory standards. Please note that the use of
this accessory with iPod or iPhone may affect
wireless performance.
If you have any questions or problems concerning
your unit that are not covered in this manual,
consult your nearest Sony dealer.

Maintenance

Replacing the lithium battery of the remote
commander
Under normal conditions, the battery will last
approximately 1 year. (The service life may be
shorter, depending on the conditions of use.)
When the battery becomes weak, the range of the
remote commander becomes shorter.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replaced only with the same or
equivalent type.
22
GB
Bluetooth® USB








+ side up
Notes on the lithium battery
 Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
 Wipe the battery with a dry cloth to ensure a good
contact.
 Be sure to observe the correct polarity when installing
the battery.
 Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in
fire.
Cleaning the connectors
The unit may not function properly if the
connectors between the unit and the front panel
are not clean. In order to prevent this, detach the
front panel (page 7) and clean the connectors with
a cotton swab. Do not apply too much force.
Otherwise, the connectors may be damaged.
Notes
 For safety, turn off the ignition before cleaning the
connectors, and remove the key from the ignition
switch.
 Never touch the connectors directly with your fingers
or with any metal device.

Specifications

Tuner section
FM
Tuning range:
87.5 – 108.0 MHz (at 50 kHz step)
87.5 – 108.0 MHz (at 100 kHz step)
87.5 – 107.9 MHz (at 200 kHz step)
FM tuning step:
50 kHz/100 kHz/200 kHz switchable
Antenna (aerial) terminal:
External antenna (aerial) connector
Intermediate frequency:
FM CCIR: -1,956.5 to -487.3 kHz and
+500.0 to +2,095.4 kHz
Usable sensitivity: 8 dBf
Selectivity: 75 dB at 400 kHz
Signal-to-noise ratio: 73 dB
Separation: 50 dB at 1 kHz
Frequency response: 20 – 15,000 Hz