geberit ESG 40/200 Instrucciones De Uso página 20

Operating instructions ESG 40/200
Troubleshooting
If the or
process has been prematurely aborted due to a malfunction.
Disconnect the mains plug so that the trouble indication goes out and the
malfunction can be corrected.
Error Cause
and Malfunction of the
light up mains voltage
(undervoltage)
Malfunction of the
mains voltage
(overvoltage)
and Malfunction on the
light up sleeve during
welding
and Device
light up temperature is too
high
and Ambient
light up temperature is too
low
, and Fault current has
light up been activated
lights up Malfunction inside
the device
20
inaktiv / inactive
indicator and an additional indicator light up, the welding
Actions
• Disconnect other devices from the power
supply system
• Use a generator with a higher power
• Connect additional consumers to the mains /
generator
• Check the contacts of the sleeve connection
cable
• Use a new sleeve
• Increase the waiting time between welding
processes
• Set the device up in a location with better
ventilation
• Do not expose the device, the electrofusion
sleeve coupling or the electrofusion tape to
direct sunlight
• Set the device up in a warmer location
• Check all contacts for signs of moisture or
foreign material and dry or remove if necessary
• Return the device to the Geberit service centre