Electrical Supply; Product Description; Product Set-Up; Instructions Of Use - GYS GYSDUCTION AUTO Manual Del Usuario

(pressing on the pneumatic pedal or on the button switch on the glass inductor), and if the inductor is not close to a
piece of metal to heat within a period of 1 minute, then the product automatically stops. Release the heating command
in order to start again the heating.

ELECTRICAL SUPPLY

• Single phase electrical supply.
- Electrical voltage supply : from 100V to 265V, WITH earth.
- Below 230V : 16A protection recommended (10A minimum).
- Electrical supply frequency : 50 or 60 Hz
Check that the electrical power supply and its protections (fuses and/or circuit breaker) are compatible with the requested
current during use. The product is protected also for use with generators.
• These are A-class devices. They are designed to be used in an industrial or professional environment. In a different
environment, it can be difficult to ensure electromagnetic compatibility, due to conducted disturbances as well as radia-
tion. Do not use in an environment exposed to metallic dust.

PRODUCT DESCRIPTION

The product is ready for immediate use, once correctly connected to the electrical supply. The GYSDUCTION AUTO
consists of an inductor and an inverter power source. A powerful magnetic field is concentrated in the inductor when
the trigger is activated. When the inductor is applied close to a ferrous metal, the induction currents create heating in
the metal, without actual contact with the piece of metal to be heated. The product heats up steel, but is not adapted
to heat Aluminium, Copper or Zinc.
The GYSDUCTION AUTO product can be used for the following applications :
- Remove all adhesives, logos, plastic bands glued on the car body,
- Release metallic parts (rusty bolts, screws, spark plugs, injectors...).
- Remove sealed glass without damaging the trim (rear window, rear quarter panel, sun roof...),
- Remove anti-gravel protection (BLAXON) and seals.

PRODUCT SET-UP

Connect the product to the electrical supply.
Connect the hose with the pneumatic pedal to the front side of the product.
Connect the chosen inductor to the front panel of the product. Make sure to securely tighten the connection by toppling
down the plastic lock.
To switch ON the product, position the switch on the back of the product to the (« I ») position. The heating starts if the
inductor is placed close to a ferrous metallic part and by pressing the pneumatic foot-pedal or the switch on the inductor
in case the glass inductor is used.
1 Remote control connector
2 Inductor connector

INSTRUCTIONS OF USE

No-Load : when no metal piece to heat is detected, or if the inductor is used with a non-ferrous metal, the indicator «
no-load » switches ON.
Manual mode : in this mode, the user manually selects the heating power, from the minimum to the maximum heating
power. To enter in this mode, press the MODE key until the LED in front of « MANUAL » lights up. The digital display
shows the percentage of the maximum heating power (2400W) that the inductor can transfer to the piece of metal. The
heating power will be higher if the inductor is brought closer to the piece of metal. Beware: at maximum power, heating
12
a metal parts can be very fast !
GYSDUCTION AUTO
1
2
3
3 On/Off switch
EN