CAIRE Companion 5 Manual Del Usuario página 5

4 Power On and Warm Up
Plug the AC power cord into an AC outlet.
Toggle the Power Switch to the On position.
When the Companion 5 is powered on properly,
the green power indicator on the LED Display will
light up. All LED lights will illuminate upon start-
up. After the concentrator completes the warm-up
cycle, only the green light will remain on.
Note: After initially powering ON the device, please
allow up to ten (10) minutes for the device to
reach its performance specifications.
For OCSI Models: The O2 Light will illuminate
for four (4) seconds upon start-up. After this initial
start-up, this light is disabled for approximately
five (5) minutes while the concentration rises to
specifications.
6 Adjust Flow Setting to Prescribed
Level
Use the Flow Control Knob to select the flow
prescribed by your physician.
Power
Switch
WARNING: IT IS VERY IMPORTANT
TO SELECT ONLY THE PRESCRIBED
LEVEL OF OXYGEN. DO NOT CHANGE
THE FLOW SELECTION UNLESS
YOU HAVE BEEN DIRECTED TO DO
SO BY A LICENSED CLINICIAN. THE
OXYGEN CONCENTRATOR MAY BE
USED DURING SLEEP UNDER THE
RECOMMENDATION OF A QUALIFIED
CLINICIAN.
Breathe normally through the nasal cannula.
To adjust flow rate:
Turn counter-clockwise to increase flow.
Turn clockwise to decrease flow.
The middle of the ball indicates flow rate. See
picture below.
Power
Indicator
LED
Companion 5
PN 15062781-C4 H | User Manual 5 - ENG