AEG MDE 1200 Instrucciones De Uso página 5

Switching off the
stand
Setting the
no–load speed
Inserting tools
Inserting a core
hole drill bit
Drilling
ENGLISH
Release the black buttom
Magnet and machine will turn off!
For safety reasons, the push-button of the main switch is recessed when switched
on.
If the machine is not used for a longer period while the magnetic field is activated,
a short–interval signal tone indicates this state every 5 minutes.
Motor protection device controlled by motor load – heat controlled shut-off if
overloading is great.
The machine will slowly continue to run in order to cool the motor down. After
sufficient cooling machine can be restarted by switching off and on again.
Speed pre–selection
with setting wheel.
A = lowest speed
G = highest speed
The table shows standard values when using core hole drills.
Always disconnect the plug from the socket before carrying out any work on the
machine.
The receiver shaft for core hole drill bits must be mounted.
1.
Insert the brad point into the receiver shaft.
2.
Insert the core hole drill bit into the
receiver shaft. The flattened sides must
face the borings in the fixing screws.
3.
Fasten the core hole drill bit with the two
screws.
Clean the surface of the workpiece. Remove any rust, dirt, or grease. If necessary,
remove any unevennesses as well as welding leftovers. A thin layer of grease does
not matter.
Punch–mark the spot to be drilled and apply the drill stand with the drill tip above the
punch mark.
Switch on the main switch and the magnet switch to check perfect fixing of the drill
stand.
4
. . . . .
A
. . . .
G
600
400
200
A B C D E F G
42 32 22 14
42 32 22 14 10
G
MDE 1200