Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Notes
• Strong sunlight can affect functioning of the product.
• Direct sunlight can damage the suction cup and
adhesion if the temperature inside the vehicle exceeds
70°C (158°F).
• The suction cup is suitable for attaching to a smooth and
clean surface for a limited time only.
• No liability is accepted for damages caused by misuse of
the product or by failure to observe the safety guidelines.
Installation Instructions
1. Fastening the holder on the
holding arm:
a. Insert the suction cup's
4 claws into the holder's
4 hole system. Hold it
vertically so that the
2 holding feet face
downward.
b. To connect securely, push the
holder downward until it clicks
into place.
c. To remove the holder, push it upward.
2. Fastening the suction
cup to the windscreen
a. The ambient temperature should
be above 15°C (59°F) for an
optimal and secure adhesion of
the suction cup. If the
ambient temperature
is not above 15°C (59°F),
warm the surface with a hair-
dryer. Press the sucker firmly
onto the base and move the
suction lever 1 to create a
vacuum between the base
and the sucker.
b. In order to remove the fastening system from the base, pull
up the suction lever 1 and pull on the vacuum tab 2 to
release the vacuum.
7159_LB5_ES_IT_PT_GB_DE_140704.indd 15
04.07.14 14:07
Publicidad
Tabla de contenido
