Safety Instructions - ULTIMATE SPEED RACING Instrucciones De Montaje

List of pictograms used
Please read the operating instructions!
Danger of suffocation! Keep the packaging out of reach
of small children.
Observe the warning and safety instructions!
Wash the covers by hand
"Racing" car seat cover set
Introduction
We congratulate you on your purchase. You have chosen a high
quality product. The instructions for use are to be considered as
part of this product. Before using the product, please familiarise
yourself with all the safety information and instructions for use. Only use the
product as instructed and only for the stated areas of use. If you pass the pro-
duct on to anyone else, please ensure that you also pass on all the documen-
tation with it.
Intended use
Set of car seat covers for the driver's seat, passenger's seat and the back
seats of cars (according to the enclosed type list).
Scope of delivery
4 x front seat covers (2 seating
covers and 2 backrest covers)
1 x cover for rear backrest
(separable into 1 to 5 pieces)
Metal hooks
277810_uls_Autositzbezug-Set_Racing_content_OS.indd 7
5 x covers for headrests
1 x cover for back seat
(not separable)
Note: A brochure with safety
instructions and a type plate are
included.
Do not use bleach
Do not dry in a tumbler
Do not iron
Do not dry clean

Safety instructions

Correct installation res. fastening of the seat covers to the vehicle is essential
to guarantee the safety of the user. Please pay attention to the following in-
formation when installing the seat covers:
DANGER OF SUFFOCATION! Keep
the packaging out of reach of small children.
Installation is permissible only in cars that are indicated in the list of types
on the packaging or in the enclosed, detailed list of types.
Correct assignment of the seat (driver and front passenger seat). The
covers are assigned by the marking „airbag" attached to the seat cover.
This marking must be attached to the outer side of the backrest
(see fig. 1.0).
Fig. 1.0
Headrest inserts, adjustment levers / wheels for release of backrests or
armrests may not be covered with the seat cover. Allowances must be
made for appropriate inserts. Please observe the instructions given in
section "Installation".
Displaced seat covers must be repositioned. If this is no longer possible
due to a advanced state of wear and tear, the cover must be removed or
replaced.
Manipulation of the opening of the seat covers is not permissible
(no covering, sewing up or repairs by yourself).
This protective cover has been tested by DEKRA AUTOMOBIL GmbH.
CAUTION! If the seat covers are installed incorrectly, the proper extension
and inflation of the seat air bag cannot be guaranteed in the case of a
collision.
Installation
You need a pair of pointed scissors.
Installation of seat covers
Important: Please read the information below before installing the seat covers!
Fig. 1: Remove headrests (in some car models the headrests must
be dismantled in a garage).
GB/IE 7
07.10.16 15:45