Continued from page 26
See the citquit board illustration above right
10. Gently disconnect all the cable sockets one by one and set them aside.
A. main wire harness
B. meat probe wire 1
C. meat probe wire 2
D. cabinet temperature sensor wire
E. door switch wire
11. Remove phillips screws ( 1 - 4 )holding down the display board.
12. Gently remove the board from it's location.
13. While removing the board, watch the USB port so it does not get stuck behind the panel edge.
14. Reinstall the the new display with reverse order of steps described above.
9.
Press down the door button and gently apply downward
motion to entire vertical metal panel till it releases.
See the illustration to the left
27 |
P a g e