Stihl HTE 60 Manual De Instrucciones página 42

English
The shaft should always be held at an
angle of 60° or less.
The least tiring working position is a tool
angle of 60°.
Any lesser angle may be used to suit the
situation concerned.
40
Cross-cut
To avoid pinching the chain in the cut,
position the cutting attachment with the
hook against the branch and then
perform the cross-cut from the top
downwards.
Relieving cut
2
To avoid tearing the bark on thick
branches, always start by performing a
relieving cut (1) on the underside of the
branch.
N
To do this, apply the cutting
attachment and pull it across the
bottom of the branch in an arc as far
as the bar nose.
N Perform the cross-cut (2) – position
the bar with the hook against the
branch and then perform the cross-
cut.
Flush-cutting thick branches
1
N
If branch diameter is more than 10
cm, first perform undercut (3) and
then cross-cut at a distance of about
20 cm (A) from the final cut. Then
carry out the flush-cut (4), starting
with a relieving cut and finishing with
a cross-cut.
A
3
4
HTE 60