Dremel 7020 Traducción De Las Instrucciones Originales página 13

Model number . . . . . . . . . 7020-PGK
Voltage Rating . . . . . . . . . . . 6.0V
Rated Speed . . . . . . . . . . . . 7000-18000 /min.
Collet capacity . . . . . . . . . . . 3.2 mm
Batteries . . . . . . . . . . . . . . . 4 x AA/1.5V
A Shaft-lock button
B
Switch
C
Battery adapter
D
Collet nut
E
Collet
F Nose cap
G Shaft
H Unlocking button
I Collet wrench
J Pet grooming attachment
(AT01-PGA)
K Clear cap
L Clamp
ALWAYS TURN OFF THE TOOL BEFORE CHANGING ACCESSORIES, CHANGING
COLLETS, OR SERVICING THE TOOL
BATTERIES 5
To insert batteries Y (not included), press unlocking buttons H of battery adapter C
and pull it off the tool.
Place the batteries in adapter C (pay attention to correct polarisation) and slide the
adapter onto the tool until you feel it click into place.
To remove the batteries, press unlocking buttons H and pull off battery adapter C
(take care that the batteries do not fall out).
Always replace all batteries at the same time.
Only use batteries from one brand and with the identical capacity.
Always remove the batteries from the tool when not using it for extended
periods.
Only use battery adapter C with Dremel model 7020-PGK.
Only use AA/1.5V non-rechargeable alkaline batteries with this tool.
Remove exhausted batteries from the tool.
TO MOUNT MANDREL 6
Unscrew and remove the nose cap F from the tool by twisting it counter-clockwise
until it comes off the tool.
To loosen the collet nut, first press shaft-lock button A and rotate the collet nut D by
hand until the lock engages the shaft preventing further rotation.
! Do not engage shaft-lock while the tool is running
With the shaft-lock A engaged, loosen the collet nut D (turn counter clockwise). Use
the wrench I if necessary. The collet nut must be loosely threaded on when inserting
an accessory. Insert mandrel R into collet E.
Make sure the blue spacer S on the mandrel bottoms out on the collet nut (setting
the mandrel to the correct depth).
With the shaft-lock A engaged, tighten the collet nut D securely (turn clockwise) with
wrench I.
NOTE: If the mandrel does not fit into the collet, it is possible that the collet is stuck
within the collet nut. If this happens, remove the collet nut from the tool by continuing
to twist it counterclockwise. If the collet does not separate from the collet nut when
removed from the tool, push the shank of the mandrel R into the hole in the collet nut
D. This should cause the collet E to pop out of the collet nut.
Re-assemble by placing the collet E into shaft G and twisting the collet nut D
clockwise over the collet to tighten it back onto shaft G.
SPECIFICATIONS
PET GROOMING KIT
ASSEMBLY
13
5
M Hinge
N
Sanding disc opening
O Small knob
P
Height adjustment slot
Q Ramp
R Mandrel (SC402)
S Blue spacer
T Spring-loaded sleeve
U Interface on mandrel
V Sanding disc (SD60-PGK) (3x)
W Interface on sanding disc
Y Battery AA/1.5V (4x)
(not included)