Safety Tips; Maintenance And Cleaning; Service And Warranty - Dremel 7020 Traducción De Las Instrucciones Originales

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 83
NAIL GROOMING A q
! Never hold the tool by the attachment. Holding the tool by the attachment
could cause it to unexpectedly shift, causing loss of control.
Place the pet's paw on the ramp Q so that the nail is close to - but not touching - the
sanding disc V.
Turn the tool on by sliding switch B to 'LO' (1) position, which corresponds to
approximately 6500 RPM. Speed setting 'HI' can be used too, if this is comfortable
for you and your dog.
Support the toe and nail in one hand while using the rotary tool in the other hand.
This is more comfortable for your pet as it lessens vibration on the paw.
Pushing gently on the bottom of the paw's pad extends the nail slightly for easier
grooming.
It is important to let the speed of the rotary tool do the work; never apply pressure to
the toenail with the spinning sanding disc. Pressure may cause the nail to grow too
hot, resulting in discomfort for your pet.
The spinning sanding disc should not be kept against the nail longer than three
seconds at a time.
Instead of focusing on completing one nail at a time, it is recommended to briefly trim
each nail on one paw, and then the other, in several passes. This allows time for the
nails to cool. You may repeat this process as needed.
Trim nails so that they almost touch the ground when your pet is walking.
Turn the tool off by sliding switch B to 'OFF' (0) position.

SAFETY TIPS

Some pets may become nervous in the presence of the tool so it is best to
secure your pet. The operator will need both hands to groom the nails so it may be
helpful to have another person assist in restraining your pet.
If hair is accidentally caught in the rotary tool, Immediately turn off the tool
and untangle the hair from the tool. For pets with particularly long hair, use an old
sock to cover the toe, foot, and leg of the pet and isolate the nail. Push the nail out
through a small opening at the tip of the sock to groom the nail.
Keep styptic powder on hand in case of bleeding. Styptic powder is available at most
pet supply stores. Follow the directions on the packaging for proper use instructions.
TO AVOID ACCIDENTS, ALWAYS DISCONNECT THE TOOL AND/OR
!
CHARGER FROM THE POWER SUPPLY BEFORE CLEANING
The tool can be cleaned most effectively with compressed dry air. Always wear
safety goggles when cleaning tools with compressed air.
Ventilation openings and switch levers must be kept clean and free of foreign matter.
Do not attempt to clean the tool by inserting pointed objects through an opening.
Remove the pet grooming attachment from the tool as needed to clean out any nail
dust or debris.
Wash only the attachment with warm water and dry thoroughly with a clean cloth
before reinstalling on tool.
CERTAIN CLEANING AGENTS AND SOLVENTS DAMAGE PLASTIC PARTS.
!
Some of these are: gasoline, carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents that contain ammonia.
NO USER SERVICEABLE PARTS INSIDE. PREVENTIVE MAINTENANCE
!
PERFORMED BY UNAUTHORIZED PERSONNEL MAY RESULT IN
INCORRECT CONNECTION OF INTERNAL WIRING AND COMPONENTS WHICH
COULD CAUSE SERIOUS HAZARD.
We recommend that all tool service be performed by a Dremel Service Centre.
This Dremel product is guaranteed in accordance with statutory/country-specific
regulations; damage due to normal wear and tear, overload or improper handling are
excluded from the warranty.
In case of a complaint, send the undismantled tool or charger and proof of purchase
to your dealer.

MAINTENANCE AND CLEANING

SERVICE AND WARRANTY

15

Publicidad

Tabla de contenido
loading

Tabla de contenido