Attaching Or Removing Bat- Tery Pack - Panasonic EY7542 Manual De Instrucciones

Ocultar thumbs Ver también para EY7542:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
injury, user must read and
WARNING
• Do not use other than the Panasonic
battery packs that are designed for
use with this rechargeable tool.
• Panasonic is not responsible for any
damage or accident caused by the
use of the recycled battery pack and
the counterfeit battery pack.
• Do not dispose of the battery pack in
a fire, or expose it to excessive heat.
• Do not drive the likes of nails into the
battery pack, subject it to shocks, dis-
mantle it, or attempt to modify it.
• Do not allow metal objects to touch
the battery pack terminals.
• Do not carry or store the battery pack
in the same container as nails or simi-
lar metal objects.
• Do not charge the battery pack in
a high-temperature location, such
as next to a fire or in direct sunlight.
Otherwise, the battery may overheat,
catch fire, or explode.
• Never use other than the dedicated
charger to charge the battery pack.
Otherwise, the battery may leak,
overheat, or explode.
• After removing the battery pack from
the tool or the charger, always reat-
tach the pack cover. Otherwise, the
battery contacts could be shorted,
leading to a rick of the fire.
• W h e n t h e B a t t e r y P a c k H a s
Deteriorated, Replace It with a New
One.
Continued use of a damaged battery
pack may result in heat generation,
ignition or battery rupture.
EY7542(EU).indb 10
To reduce the risk of
understand instruction
manual.
For indoor use only.
- 10 -
III. ASSEMBLY
Attaching or Removing Bit
NOTE:
• When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center position
(switch lock).
1. Hold the collar of quick connect chuck
and pull it out from the driver.
2. Insert the bit into the chuck. Release
the collar.
3. The collar will return to its original
position when it is released.
4. Pull the bit to make sure it does not come
out.
5. To remove the bit, pull out the collar in
the same way.
CAUTION:
• If the collar does not return to its
original position or the bit comes out
when pulled on, the bit has not been
properly attached. Make sure the bit
is properly attached before use.
Use 6.35 mm hexagonal bits.
To ensure proper securement of the
bit, use only hexagonal bits with 9.5
mm detent.
6.35 mm
Attaching or Removing Bat-
tery Pack
1. To connect the battery pack:
Line up the alignment marks and at-
tach the battery pack.
• Slide the battery pack until it locks
into position.
Alignment marks
2. To remove the battery pack:
Pull the button from the front to re-
lease the battery pack.
9.5 mm
2012-10-12 15:38:31

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ey7549ls2sEy7549x

Tabla de contenido