Tabla de contenido
Publicidad
The appliance has been tested before being put
into service. The information provided below
is intended to assist in the identifi cation and
correction of any anomalies and malfunctions
which might occur during use.
The user can solve some of these problems
himself, but for others specifi c technical knowl-
edge or skill is required, and so they must only
be carried out by qualifi ed staff with recognised
experience acquired in the specifi c sector of
operation.
Faults
Smell of gas
The pilot light does not
ignite
The pilot light goes out
The fl ame is yellow
Burner control knob is stiff
3319960_ut_GB_rev.1
FAULT
TROUBLESHOOTING
For all requirements contact the agents or
the headquarters of Angelo Po which can be
found in the contacts section of the website
http://www.angelopo.com.
Causes
Occasional leak because
fl ame has gone out.
Air in pipelines due to long
period out of use.
The thermocouple has not
warmed up enough.
Burner dirty
Gas control valve
malfunction.
- 11 -
Important
Remedies
Turn off the gas supply tap and
ventilate the room.
Make more attempts
to light the fl ame.
Make more attempts to light
the fl ame.
Clean the burner
Contact the after-sales service.
GB
ENGLISH
Publicidad
Tabla de contenido
