Helpful Tips; Check Point - PiC DIAGNOSTIC CS 410 Manual De Instrucciones

Helpful tips

Here are a few helpful tips to help you obtain more accurate readings:
• Do not measure your blood pressure immediately after eating a large meal. To obtain more
accurate readings, wait at least one hour before measuring your blood pressure.
• Do not smoke or consume alcohol before measuring your blood pressure.
• Do not measure your blood pressure when you are physically tired.
• It is important to relax during measurement. Try to rest for 15 minutes before measuring
your blood pressure.
• Do not measure your blood pressure if you are tense or under stress.
• Measure your blood pressure at normal body temperature. If you are feeling hot or cold, wait
a while before taking a measurement.
• If the monitor is stored at very low temperature (near freezing), put it in a warm place for at
least an hour before use.
• Leave at least 5 minutes between each measurement.
Troubleshooting
If any faults should occur during use, please check the following points:
Symptom
Nothing appears on the dis-
play when the
ON/OFF/START button is
pressed
The EE symbol appears on
the display or the blood
pressure value is excessive-
ly high or low
Note: If the unit still does not work, take it to an authorised Artsana service centre. Under no
circumstances should you disassemble and attempt to repair the unit yourself.
Warnings:
1. The appliance contains high-precision components. Therefore, avoid extreme temperatures,
humidity and direct sunlight. Avoid dropping or vigorously shaking the main unit and pro-
tect it from dust.
2. Clean the monitor body and armband carefully with a soft and slightly damp cloth. Do not
press. Do not wash the armband or use chemical cleaners on it. Never use thinner, alcohol
or petrol as cleaning fluids
3. Batteries that leak can damage the unit. Remove the batteries if the unit is not used for long
periods.
4. For safety reasons do not let children use the device.
5. If the unit is stored at temperatures near freezing point, allow it to acclimatize at room tem-
perature before use.
6. The CS 410 is not field serviceable. Do not attempt to open the device using tools or try to
adjust anything inside it. If you have any problems, please contact an authorised Artsana
service centre.

Check point

Have the batteries run down?
Are the batteries inserted
correctly?
Is the armband correctly
applied in the proper posi-
tion?
Did you talk or move during
measurement?
Did you move your wrist
whilst wearing the armband?
16
Correction
Replace them with 4 new
alkaline batteries.
Reinsert the batteries in the
correct position.
Take the measurement again
without moving.
Take the measurement again
without moving.