Cycle.start.and.special.functions; Program.start; Changing.the.setpoint.value.during.a.firing; Jump.to.the.next.segment.during.the.cycle - Pixsys ATR 900 Manual Instalador

8 Cycle start and special functions
8.1 Program start
Press START/STOP and follow the points below:
Press
1
2
8.2 Changing the setpoint value during a fi ring.
Controller is operating a cycle: follow the points below.
Press
1
8.3 Jump to the next segment during the cycle
Controller is operating a cycle: follow the points below.
Press
1
Press the key
for 3 s.
12 - ATR 900/901 User manual
Display
Value on display changes
Program starts and buzzer sounds
briefl y. From now on, display
shows the actual temperature of
the kiln. Led START is On.
Display
Pressing the key it is possible to
visualize setpoint of current step.
If this function is active
press once again the key to modi-
fy it. After a few seconds display
will shows process and setpoint
value is stored.
Display
The con troller jumps to the next
segment of the running cycle
Main display shows
the key to scroll through the
available programs and fi nally
the function "simple controller
tErM
is displayed.
P- 14
,
Enter new setpoint value.
Do
ci c. 1
, until the chosen program
To stop or pause the
fi ring cycle, press
Do
Do
. Press
.