Tabla de contenido
Publicidad
Manage Cables - Cable Tunnel
NOTES:
●
This product is NOT recommended for brick, plaster, or
wallpapered walls.
●
If wall has been painted, allow paint to cure at least 30 days
before installing cable tunnels.
●
Wipe away any dirt, dust, grease, etc. on the surface and let dry
completely before installing.
●
The tunnels
can be painted to match your wall.
25
●
The tunnels
can be cut to fit the length required.
25
To Remove Adhesive Clips
1.
Insert a flat object (e.g. - knife blade) behind the clip and the
adhesive pad and pry off the plastic clip.
2.
Peel off the adhesive pad with your fingers.
3.
If adhesive residue remains, use a cloth soaked in an organic
solvent to wipe away the residue.
NOTE: First test the solvent in a concealed spot to make
sure it will not damage the wall surface.
1
Space clips
evenly along the length of the tunnel(s)
23
with a clip near each end. To combine tunnels, use the long
clip
to connect where they meet.
24
A
Press firmly until clips snap in place.
B
Peel off backing of adhesive pads on clips.
NOTE: If using two tunnels, install five clips - four
clips and one long clip
If using only one tunnel, install three clips
TIP: If the edges of the two tunnels do not align, reverse
one tunnel end for end.
23
A
.
24
.
23
24
23
B
25
23
17
Publicidad
Tabla de contenido
