Water Installation; Water Inlet - Salva IVERPAN FC-18 Instrucciones De Usuario

4.5. Water installation

4.5.1. Water inlet

4.5.2. Drain
Usuario_Iverpan2006_(c-f-i)011210
For the connection a rubber hose, provide by SALVA S.A., can
be used which is similar to those used for the water inlet of
washing machines.
NOTE : For those cases in which water is calcareous, it is
necessary to install a water softener between the water
supply and the Iverpan intake. (Not supplied with the Iver-
pan).
The water supply inlet pressure must be aproximately 1-1,5
kg/cm2
VERY IMPORTANT :
the main water supply a manual shut-off cock must be
installed. This should always be shut off when the Iverpan
is out of service.
Always take into account that for correct performance, the
Iverpán needs to be connected to a drain. A rubber hose of 12
mm. inner diameter can be used for this drain connection.
The Iberpán drainhose must be connected to the drainage of
the room.
To avoid bad smell, a U-trap must be installed between the
refrigerator drain outlet and the drainage connection of the
room.
-89-
Between the Iverpan water inlet and
salva