Programming Operating Modes - Salva IVERPAN FC-18 Instrucciones De Usuario

6.2. Programming operating modes

6.2.1. Chill Function
6.2.1.1. Function displays:
Description
6.2.1.2.
Usuario_Iverpan2006_(c-f-i)011210
The following figures show an example of the function displays
in this operating mode.
COLD TEMP.
001ºC
The symbol corresponding to this function is displayed at the
bottom right-hand side.
In this operating mode, the FC95LC electronic control main-
tains a temperature that can be programmed by the user un-
definedly.
Relative humidity is not programmed or controlled in this ope-
rating mode.
Selection method:
Press the <CHILL> key (4) . The following message will
appear on the display:
COLD TEMP.
XXXºC
The < > <
perature at which the chamber is to be maintained.
Press the < ENTER > key to enter the selected temperature
into the memory and start the operation.
The display shows the following message:
PROG.TEMP.
XX ºC
In this way, the progress of the real temperature compared to
the programmed one can be observed.
To abandon this working mode, the following method should
be used:
Press the <CHILL> key (4)
On pressing this key, the following message is shown on the
display:
-95-
> keys are used for selecting the tem-
REAL TEMP.
XX ºC
salva