Alesis MasterControl Manual De Inicio Rápido página 10

(F) MONITORING / CONTROL ROOM FEATURES
1
1. DIRECT MONITOR – Use this function to listen to your input sources without the latency
introduced by your computer. When lit, this button switches the channel strips from controlling
your computer software to controlling the volume and pan of your input signals.
MasterControl's Hardware Direct Monitoring allows you to route your inputs directly to your
outputs, skipping the computer round-trip and therefore lowering latency to near zero.
Note: When using the MasterControl's direct monitoring features, disable input monitoring in your
software. Otherwise, you will hear an echo.
2. DIRECT MON LEVEL – Raises or lowers the level of the entire direct monitoring mix.
3. OUTPUT 1-2 LEVEL – Controls the volume of your computer's Output Source 1/2 for those line
outputs that are set to "listen to" outputs 1/2. (Set the assignments for the line outputs in the
GLOBAL menus.)
4. HEADPHONE 1 / 2 – Controls the volume for the MasterControl's HEADPHONE 1 and 2 outputs,
respectively. These volumes are not affected by the OUTPUT 1/2 LEVEL knob.
5. SPEAKERS / OUTPUTS – Press these buttons to activate (lit) or mute (unlit) the corresponding
MONITOR / LINE OUTPUTS.
6. TALKBACK – Hold this button down to engage "talkback" so you can speak to your musicians
using the built-in talkback microphone.
7. LED METERS – These meters measure the audio signal level of the Output Source 1/2 sent from
your computer software to the MasterControl.
7
8
5 5 5
6
2
3
4
4
The