Publicidad
Idiomas disponibles
Idiomas disponibles
F F
F F
r r
r r
o o
o o
n n
n n
t t
t t
P P
P P
8
A.
INPUT - Plug your bass in here. NOTE: This jack
overrides the rear panel Input jack {EE}.
B.
–6 dB PAD - Reduces the Input sensitivity to allow
cleaner response with high-output bass guitars.
C.
VOLUME - Adjusts the loudness of the Vintage
Tube Tone.
D.
BASS / MID / TREBLE - Classic, cut only tone
stack. Pull the Bass knob out for a boost in the low-
frequency range. Pull the Treble knob out for a
boost in the high-frequency range. Bright boost is
more apparent at mid settings of the Volume
control {C}.
E.
ENABLE - Switches the Tube Overdrive section
on/off as indicated by the LED. Keep button out for
proper operation of the included footswitch.
F.
GAIN - Adjusts the Tube Overdrive distortion level.
G.
VOLUME - Adjusts the loudness of the Tube
Overdrive sound along with the Gain control {F}.
H.
BLEND - Adjusts the mix of clean vintage tube tone
with overdriven tube tone when the Tube Overdrive
is enabled.
I.
ENABLE - Switches the Vari-Q™ semi-parametric
EQ section on/off as indicated by the LED. Keep
button out for proper operation of the included
footswitch.
J.
FREQ - Selects the center of frequency range that
the Level control {K} adjusts. NOTE: This knob has
no effect when Level is at "0."
w
w w
w w
w . . f f e
e n
n d
d e
a a
a a
n n
n n
e e
e e
l l
l l
e r
r . . c
c o
o m
m
K.
LEVEL - Adjusts the amount of boost or cut
(±15dB) at the frequency selected by the Freq
control {J}. Also adjusts the width or "Q" of the
frequency response as appropriate. In the boost
mode, the "Q" is automatically set wider, which is
more generally perceived as musically pleasing. In
the cut mode, the "Q" is narrow, useful to eliminate
a problem frequency, hum or resonance.
L.
ROOM BALANCE - Room Balance is for the player
to "dial in the room" as a final touch of EQ. This
feature is OFF when in the center position (start the
EQ process with this control centered; dial it in
last). Turning the control clockwise emphasizes
highs, while de-emphasizing lows (great if the stage
sound is dark and muddy). Turning the control
counter-clockwise creates the opposite effect;
emphasizing lows while de-emphasizing highs
(helps with bright hardwood floors). This frees up
the EQ of the TBP-1 to design your TONE instead
of compensating for poor room acoustics.
M. MASTER VOLUME- Adjusts the overall loudness
of the TBP-1 in conjunction with the Gain and
Volume controls of active sections.
N.
MUTE - Disables all TBP-1 outputs (except for the
Tuner and FX Loop Send jacks) as indicated by the
blinking LED. Keep button out for proper operation
of the included footswitch.
O.
POWER - Switches the TBP-1 on/off as indicated
by the LED.
w w
w
w w
w . . m
m r
r g
g e
e a
a r
r h
h e
e a
a d
d . . n
n e
e t
t
Publicidad
