Main Output - Fender TBP-1 Instalación Y Funcionamiento

P. IEC POWER SOCKET - Connect the included
power cord to a grounded AC receptacle in
compliance with the voltage and frequency ratings
specified on the rear panel of your TBP-1.
Q. FOOTSW - Connect the included footswitch to
enable remote on/off switching of Tube Overdrive,
FX Loop, Vari-Q™ and Mute. NOTE: For proper
operation, front panel switches {E}, {I} and {N} must
each be left in the out, non-enabled position.
R. LF OUT - Low frequency output for bi-amping.
S. BALANCE - Adjusts the balance between the
LF Out and HF Out when bi-amping.
T. HF OUT - High frequency output for bi-amping.
U. FREQUENCY - Adjusts the crossover frequency
when bi-amping.
V. MAIN OUTPUT - Full-range output for connecting
to a power amp input or to a bass amp Return jack.
W. GND / LIFT - The Ground Lift switch should
normally be in the Ground (out) position. In the Lift
(in) position, the ground connection (pin-1) of the
Balanced Line Out jack {X} is disconnected from
the chassis, which may reduce hum noise in some
situations.
X. BALANCED LINE OUT - This jack allows you to
send a Jensen™ transformer isolated, hum-free
signal from the TBP-1 to external equipment (such
as a house mixing console or a recording device).
NOTE: Jacks {R}, {T}, {V}, {CC} and {DD} are balanced TRS (Tip/Ring/Sleeve) types, with
tip=positive (+), ring=negative (–) and sleeve=ground (GND). While standard sheilded TS
(Tip/Sleeve) "mono" guitar cables may certainly be used, the use of "stereo" TRS cables,
when available, may improve signal-to-noise ratio and/or reduce hum.
w w w w w w . . f f e e n n d d e e r r . . c c o o m m w w w
Y. LEVEL - Adjusts the output level of the Balanced
Line Output jack {X}.
Z. PRE / POST - Use this control to select if you
would prefer the bass signal from the Balanced
Line Output {X} to be affected by the EQ changes
you make (post) or before the EQ, to give an
unaffected signal (pre).
AA. TRIM - Adjust to compensate for external effects
devices volume difference when FX Loop is
selected with included footswitch. Full clockwise
rotation provides a +6dB boost, while full counter-
clockwise provides a -6dB cut. Also useful for a
footswitchable solo boost (clockwise rotation)
when not using external effects.
BB. –10dBV / +4dBu - FX Loop level. Sets nominal
operating level for external effects. Use +4dBu for
professional rack-style effects. Use -10dBV for
battery operated pedal effects.
CC. RETURN / SEND - FX Loop jacks for external
effects. Connect Send to the input of your effects
device and Return to the output of your effects
device.
DD. TUNER - Connection for your bass tuner. Use the
Mute switch {N} while tuning, if desired.
EE. INPUT - Alternate connection for bass guitar
signal. Useful in some rack configurations. NOTE:
Front panel Input jack overrides this jack.
w w w . . m m r r g g e e a
R R R R e e e e a a a a r r r r P P P P a a a a n n n n e e e e l l l l
a r r h h e e a a d d . . n n e
9
e t t