Rear Side; Battery Block; Maintenance Instructions - Georges Renault DELTA4000 Manual Operario

6159938010-07
English
6 / 200
¡
To exit a screen without saving changes.
¢
To exit a screen and save the changes.
¥
To open the print request screens.
¤
To perform an Automatic Zero Correction ( AZC) on the transducer.

2.2 - Rear side

DRT digital transducer
(torque or torque and angle)
Parallel printer
SubD 25 points
Analog torque and angle
connector
(for the DELTA5000)
Charge indicator lamp
* To install the strap holder, untighten the two screws and re-secure the holder with the screws.
** DELTA4000/5000 only

2.3 - Battery block

The battery block is extractible and consists of 6 x 1.2 V (7.2 V) NimH elements, rechargeable inside or outside the
unit. P.N.: 6159350420.
Battery life is 14 hours.
It allows up to 1000 Discharging/Recharging cycles.
Automatic stop when the unit is idle is programmable (see "Service" menu).
When the battery indicator blinks on the screen on the front side, it is necessary to recharge the battery block using the
charger supplied with the unit.
- The battery indicator crossed out means a connection fault with the battery block.
- When blinking, the charge indicator lamp located on the left side of the charger socket means that the cable is
correctly connected and the charging of the battery block is running smoothly.
- When the lamp is on, it means that the charging process has been completed.
Battery block opening procedure:

2.4 - Maintenance instructions

Any maintenance task shall be performed by CP authorised representatives
DELTA4000/5000/4D/5D
PC connection SubD 9 points
Strap holder*
Input/output connection
SubD 15 points
Analog torque transducer
(for the DELTA4000/
5000**)
Battery charger socket