Measuring - Georges Renault DELTA4000 Manual Operario

3 - MEASURING

Check that the cables are connected correctly on the rear side of the unit.
When switched on, the unit displays the name of the task under way.
The standard acquisition screen is as follows:
Name of task
Angle measured on 7 digits (for
the DELTA 5000/5D)
Number of measurements out
of programmed total number
Summary line
Operating Mode
Battery indicator
According to the "type of measurement" programmed in the task selected, the display is as follows:
T torque only, torque mean and range, torque report
T + A torque in large characters, angle in small characters, torque mean and range, torque and angle report
(for the DELTA5000/5D)
A + T angle in large characters, torque in small characters, angle mean and range, torque and angle report
(for the DELTA5000/5D)
To move the cursor upwards or downwards, press
To change a parameter, press
¤
Press to reset the measurement if required.
Caution: the transducer must be stress-free.
¢
Press to store a value (in manual reset mode)
Tightening report symbols:
¯
: Accept report (value between min. and instruction)
°
: Accept report (value between instruction and max.)
±
: Reject report and above tolerances (higher-than-max. value)
²
: Reject report and below tolerances (lower-than-min. value)
The corresponding LED lights up on the front side of the unit.
The reports are also available on the Input/Output connector (see Appendix).
To exit the "Acquisition" menu, press
Task
Move the cursor to the first line and press
To shift from one task to another, use the
Selecting from a long list of tasks is made easier by pressing an "alphanumerical" key:
The list of tasks is displayed in alphanumerical order.
Press an alphanumerical key again: a window opens to allow you to enter the first letter(s) of the name of the task you want
DELTA4000/5000/4D/5D
TASK 0001
10.50
50.00°
Meas. : 0 / 50
x10.00
[-]
t
Ar
ª
or
¨ © {
or and then .
¡
.
{
to modify the task in progress.
¨ ©
or arrow keys.
Value measured on 5 digits + decimal point
A blinking "----" sign indicates an overflow.
Nm
+
Tightening report
10%
Additional measurements
08 : 29
Time
«
.
6159938010-07
English
7 / 200