Operating Mode - Georges Renault DELTA4000 Manual Operario

6159938010-07
English
8 / 200
¢
to find. Press to validate.
It is possible to create up to 1 000 tasks ("Parameter/Task" menu).
Each task can include from 1 to 5 000 measurements depending on the number of tasks already stored.
Additional measurements
¨ ©
Using the or keys, the operator will display the following items on this line:
- Mean and range of the last 5 measurements
- The result of the PreCAM calculation on the last 5 measurements: dispersion and centering values or accept/reject
report only.(refer to Appendix for calculations).
- The instruction and the tolerances (which can be programmed in the "Task" menu)
- The number of "peaks" when the task is in "hydro" measuring mode.
Time
The "Service/Date" menu allows the operator to set the date and time of the unit.

Operating Mode

S t P m R
Type of application:
St Standard
H Hydro
Torque reading in manual mode:
T Track mode.
The actual value of the torque is displayed continuously. This mode is generally used to test the measuring line.
P Peak mode.
This mode is the standard mode of acquisition: the "peak" value of the measurement is displayed and stored.
Torque reading direction:
*
"tightening" mode or rightward rotation
(
"untightening" mode or leftward rotation
)
combined "tightening" and "untightening" mode
Enabling the validation of the curve:
³
indicates that the validation of the curve is enabled (no symbol displayed means that the validation is disabled)
Manual or automatic reset:
mR Man reset. When the maximum number of measurements is reached, you cannot save any other: by pressing
you can only reset the display. Use the "Results/Measurements" menu to erase them in order to save new meas-
urements. Press
aR Auto reset (automatic reset). For further details, see "Task" menu.
Sequence of tasks:
As Automatic sequencing. The tasks to be performed are selected in the increasing order of creation of stations (see
"Task/Parameters/Select" menu). When all the measurements of a task have been obtained, the unit automatically
starts the next task.
When the measurements in the last task have been obtained, the measurement mode is locked: the measurements
must be downloaded and the memory must be dumped to be able to continue.
When the automatic sequencing is not selected, the As symbol is not displayed.
A s
¢
to save the measurement.
DELTA4000/5000/4D/5D
¢