Dynamic (Animal) Weighing; Manual Mode; Auto Mode - Adam Nimbus NBL Series Manual Del Usuario

EN
10.4.3

Dynamic (Animal) Weighing

The balance can be set to weigh animals or unstable/moving items. This is commonly
referred to as 'Dynamic' or 'Animal' weighing mode. The balance will collect the weight
over a period of time to arrive at an average value and display the value until the operator
resets the balance. The actual weighing process can begin either automatically when the
weight is placed on the pan, or when initiated by the operator. The weighing unit can be
selected as normal using the [Unit] and [Setup] keys, before starting the dynamic
weighing process.
Steps:
Press [Mode] and then the [Up] or [Down] key to cycle through available modes. When
Dynamic
the " " symbol is displayed, press [Setup] to enter dynamic weighing mode. "rvn
now be displayed on the screen.
Press [Up] or [Down] to select "rvn
up the balance for dynamic weighing (see section 10.4.3.3 on Dynamic Weighing Setup
Parameters).
During dynamic weighing, if the [Print] key is pressed, the balance will display "PAvSEd
1 second, then show the current average weight with the "
To resume, press [Print] again or if you do not wish to continue then pressing [Mode] will
display "StOP StOP StOP" for one second and then show the final value. The value will be locked until StOP
the user releases it.

10.4.3.1 MANUAL MODE

When the balance is in the "MmANvAL
If [Setup] is pressed when "rvN
Place the item on the pan and press [Setup] again.
After the pre-configured delay and test time have elapsed (see section 10.4.3.3 on
Dynamic Weighing Setup Parameters), the "
Remove the item from the pan. Press [Mode] to go back to "rUN
[ 0/T] to return to normal weighing.

10.4.3.2 AUTO MODE

When the balance is in the "AvTO
If [Setup] is pressed when "rVN
Place the item on the pan. The animal weighing test will begin automatically.
After the pre-configured delay and test time have elapsed (see section 10.4.3.3 on
Dynamic Weighing Setup Parameters), the "
Remove the item from the pan. Press [Mode] to go back to "rUN
[ 0/T] to return to normal weighing.
© Adam Equipment Company 2015
rvn" for starting the dynamic weighing, or "SEtvP
rvn rvn
MmANvAL MmANvAL" mode:– MmANvAL
rvN" is selected, balance will display "StArt rvN rvN
Hold
AvTO" mode:–
AvTO AvTO
rVN rVN rVN" is selected, the balance will display "LOAd P
HOLD
Dynamic
" symbol flashing.
StArt". StArt StArt
" symbol and the result will be displayed.
rUN" to weigh another item, or rUN rUN
" symbol and the result will be displayed.
rUN" to weigh another item, or
rUN rUN
23
3016612481Rev2.00-Jul15
rvn" will rvn rvn
SEtvP" to set
SEtvP SEtvP
PAvSEd" for PAvSEd PAvSEd
LOAd P". LOAd P LOAd P