Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
e)
Avoid abnormal posture. Care for safe standing and keep the balance anytime.
Do not work on a ladder. Thus you can control the electric tool better in unexpected
situations.
f)
Wear suitable clothing. Do not wear wide clothing or jewelry. Keep hair, clothing
and gloves away from moving parts. Wide clothing, jewelry or long hair can be
caught by moving parts.
g)
If there is the possibility to assemble a dust exhauster and collecting device,
make sure that these are connected and used correctly. The use of a dust
exhauster can reduce dangers by dust.
4)
Use and handling of the electric tool
a)
Do not overload the device. Use the appropriate electric tool for your work. With
the appropriate electric tool you work better and saver in the declared range of
performance.
b)
Do not use an electric tool whose switch is damaged. An electric tool which can
not be switched on and off is dangerous and has to be repaired.
c)
Unplug the plug from the socket and/or remove the battery before carrying out
instrument settings, exchanging accessories or put the device aside. This safety
measure avoids the unintended start of the electric tool.
d)
Keep unused electric tools out of reach of children. Do not allow persons to use
the device who are not familiar with it or have not read these instructions.
Electric tools are dangerous if they are used by inexperienced persons.
e)
Maintain electric tools with care. Check if movable parts function correctly and
do not jam, if parts are broken or damaged in that way, that the function of the
electric tool affected. Have damaged parts repaired before using the device.
Many accidents originate from bad maintained electric tools.
f)
Keep the cutting tool sharp and clean. Carefully maintained cutting tools with sharp
edges do jam less and are easier to guide.
g)
Use electric tool, accessory, operation tools, etc. according to these
instructions. Thereby consider the conditions of employment and the work to be
done. The use of electric tools for others than the intended task can result in
dangerous situations.
5)
Service
a)
Have your tool only repaired by qualified personnel and only with original spare
parts. Thus it is assured that the safety of the electric tool is being obtained.
P A R T I C U L A R I N F O R M A T I O N - Please note
2.
1)
General
a)
This diamond disc saw is only intended for industrial use and may only be
operated by trained personnel.
b)
Proper use extends only to the sawing of rock, concrete and masonry.
c)
For operation the relevant regulations must be observed.
d)
Power tools must regularly (approx. 6 months) be checked on safety by a
specialist according to BGV A3.
e)
Never deposit the disc saw until the saw blade has come to a complete stop. The
rotating saw blade can get into contact with the surface whereby you may loose control
of the disc saw.
f)
Do not operate the disc saw while you carry it. Your clothes can be captured by
accidental contact with the saw blade.
18
Publicidad
Tabla de contenido
