MRA 4025066165285 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
4 Rubber spacers, 10 mm
4 Plastic washers 12x5x0.5mm
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Dismantle the original windscreen. Make sure that the spacers do not fall out of
the rubber sleeves during dismantling.
3. Insert the original screws with the plastic washers supplied [10635] through the
MRA screen and press the rubber spacers supplied [10688] against them from
behind (P1).
4. Mount the MRA windscreen to the motorcycle and tighten the screws.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW F750GS 18-
Article No..
--- Torx 25
10688
10635
3
Required tools