Remoset Function; Setting The Frequency Manually - Monacor JTS JSS-20/5 Manual De Instrucciones

3.6.1 REMOSET function

For the REMOSET function always make sure that
1 no menu is called up on the microphone or
on the receiver
2 the microphone is switched on and close to
the receiver (REMOSET transmission range:
approx 10 m)
3 the microphone and the receiver are set to the
same identification number (ID No ) or that the
function ID No is deactivated (see paragraph
"Identification number")
4 the REMOSET function is not disabled (see
paragraph "Disabling the REMOSET function")
5 the receiver and the microphone are not locked
(chapter 3 11)
6 the microphone is not muted (chapter 3 10)
– Identification number –
To prevent mutual interference of individual pairs
of microphone/receiver during REMOSET trans­
mission, each pair must have a different iden­
tification number (ID No ) If you only use one
pair of microphone/receiver, there is no need to
change the preset ID No 1 To change the ID No :
1) Call up the setting for the ID No via the menu
item
5. Device ID
Device ID
1
ID : ON
2) Press the button  or  to set the ID No
3) Press the button SET Then press the button 
to deactivate the function (OFF) or the button
 to activate the function (ON) If the function
has been deactivated, the REMOSET transmis­
sion will be possible from any UF­20R/5 or
UF­20S/5 receiver; if the function has been ac­
tivated, the REMOSET transmission will only be
possible from a receiver with the same ID No
4) Press the button SET to save the setting
16
of the main menu
Fig. 8
– REMOSET transmission –
Press the button REMOSET on the receiver As
soon as the microphone has been set to the
transmission frequency or to the group and the
transmission channel of the receiver, the LED (3)
shows blue for five seconds and the display indi­
cates
Sync...
If the LED does not show blue, the automatic
synchronization of the microphone has failed In
this case, the button REMOSET on the receiver
keeps flashing slowly For troubleshooting see
steps 1 – 6 at the beginning of this chapter Check
the settings on the microphone and possibly on
the receiver and correct them Then press the
button REMOSET on the receiver again
– Disabling the REMOSET function –
The REMOSET function can be disabled to pre­
vent automatic setting:
1) Call up the menu item
main menu
Remoset
ON
OFF
2) Press the button  to disable the func­
tion (OFF) or the button  to enable the
function (ON)
3) Press the button SET to save the setting

3.6.2 Setting the frequency manually

1) Call up the frequency setting via the menu
item
1. Frequency
Frequency
532.625
G: 1 C: 1
2) Press the button  or  to set the frequency
in steps of 1 MHz
3) Press the button SET so that the digits after the
decimal point are highlighted To make a fine
adjustment in steps of 0 025 MHz, press the
button  or  If the frequency is identical
to the frequency of a channel in a group, the
group and channel numbers are indicated in
the lower line
4) Press the button SET a second time to save
the frequency selected
in the
6. Remoset
Fig. 9
of the main menu
Fig. 10