Before Use; Installation - cecotec CONGA 1690 Manual De Instrucciones

3. BEFORE USE

• Take the product out of the box and remove all packaging material.
• Make sure all parts and components are included and in good conditions. If any visible
signs of damage are observed, contact the Technical Support Service immediately.

4. INSTALLATION

Robot and charging base installation
1. Connect the charging base to a power supply and store
the remaining cable. It is important to store the remaining
cable at the bottom of the charging base to avoid it from
being dragged and disconnected.
2. Place the charging base against the wall, leaving the
safety distance indicated in the below picture.
Note: Ensure a space of at least 1 m on both the left and
right side of the charging base, and a space of at least 2 m
in front of it.
WARNING: Do not expose the charging base to direct sun light.
3. Long press the
on the charging base.
Note:
• Take the robot to the charging base if the battery is low. The robot might not turn on if
the battery is very low.
• The robot will automatically turn on when placed on the charging base.
• The robot cannot be turned off during charging.
WET & DRY TANK INSTALLATION
Note: It is not suggested to use the scrubbing function for the first-time use.
button for 3 seconds; when the light indicator turns on, place the robot
• Steady blue light: ON/operating
• Orange light oscillates: charging
• Red light blinks: error
ENGLISH
1 m
1 m
2 m
25