Before Use - cecotec CONGA 1990 CONNECTED Manual De Instrucciones

ENGLISH
2. Clock settings
3. Automatic charge/Back home
4. Autoclean/pause
5. Direction buttons
6. Spot cleaning
7. Room cleaning
8. Scrubbing levels
9. Scheduling
10. Edge cleaning
11. Power levels

2. BEFORE USE

- Take the product out of the box.
- Remove all packaging material. Save the original box.
- Make sure all parts and components are included and in good conditions. If any visible
signs of damage are observed, contact the Cecotec Official Technical Support Service
immediately.
Warning
Remove all objects around the robot such as clothing, papers, cables, curtains or other fragile
objects. Fig. 18
If the area to be cleaned has a balcony or stairs, a physical barrier must be placed in order to
prevent product damage and ensure safe operation. Fig. 19
Direct exposure to sunlight or great light contrasts may affect the correct operating of the
sensors. If this happens and the robot stops, change it to a new location for it to start operating
again. Fig. 20
1. Place the charging base against the wall and leave a minimum free space of:
- 2 metres to the front.
- 1 metre to each side. Fig. 21
2. Connect the charging base to a power supply. Wind and store the remaining cord in the
lower part of the charging base to avoid accidents. Fig. 22
3. Install both side brushes in their corresponding slots, located on the robot's bottom part.
Press until it clicks to make sure they are properly fixed. Fig. 23
4. Press the power switch located on the bottom part of the robot. Make sure the power
switch is turned On. Fig. 24
5. Place the robot on the charging base and make sure the charging terminals on the robot
44
05660_Conga 1990 Connected_IM_YV_0121085.indd 44 05660_Conga 1990 Connected_IM_YV_0121085.indd 44 6/8/21 13:08 6/8/21 13:08