EGO POWER MOWER Manual Del Operador página 17

CAUSE
PROBLEM
Wet grass clippings are sticking to the
underside of the deck.
The mower does not
mulch properly
The mower is set to cut too much grass at
once.
The cutting blade is loose.
The cutting blade is unbalanced.
There is excessive
vibration
The cutting blade is bent.
The motor shaft is bent.
The side rails are not fully extended.
The handle locking
clamps cannot be
closed in position.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com for full terms and conditions of the EGO Warranty policy.
56 VOLT LITHIUM-ION CORDLESS MOWER — LM2010E/LM2010E-SP
SOLUTION
Wait until the grass dries before
mowing.
Raise the deck to a higher cutting
height setting.
Tighten the blade bolt.
Balance the blade following the
instructions.
Replace the blade.
Contact the service center.
Fully extend the side rails, then lock
the clamps.
EN
17