Regulations For Equipment Use; Specifications - Nintendo 3DS XL Manual Del Operador

Regulations for Equipment Use

FCC and Industry Canada Information
In order to comply with FCC radio-frequency radiation exposure guidelines for an uncontrolled exposure, this device and its antenna must not be
co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules and RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this device.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician or call Nintendo Consumer Service at 1-800-255-3700 for assistance.
The user may find the following booklet prepared by the Federal Communications Commission helpful: How to Identify and Resolve Radio-TV
Interference Problems. This booklet is available from the U.S. Government Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.
For the FCC ID number and other regulatory information, please see inside the battery cover.
76

Specifications

Nintendo 3DS XL system
Model name: SPR-001 (USA)
LCD screens Upper Screen: Widescreen LCD display, enabling 3D view without the need for special
(Screen size/pixel count) glasses. Capable of displaying approximately 16.77 million colors. 4.88-inch display
(106.2 mm horizontal x 63.72 mm vertical) with 800x240 pixel resolution (400 pixels
are allocated for each eye to enable 3D viewing).
Lower Screen: LCD Touch Screen. Capable of displaying approximately 16.77 million
colors. 4.18-inch display (84.96 mm horizontal x 63.72 mm vertical) with 320x240
pixel resolution.
Power source: AC adapter (WAP-002 (USA)), Battery pack (SPR-003)
Wireless frequency: 2.4GHz band
Wireless standards: IEEE802.11b/g
Recommended wireless distance: Within 98' (30 m). Depending on surrounding conditions, this distance may be less.
Camera functions: Lens: Single focus. Capture element: CMOS. Active pixel count: Approx. 300,000 pixels.
Clock features: Maximum daily variance: ± 4 seconds
Speakers: Stereo (with pseudo-surround support)
Input/output: Game Card slot, SD Card slot, AC adapter connector, charging cradle terminal, and stereo
headphone output jack
Sensors: Motion sensor, gyro sensor
Infrared Communications: Within 8" (20 cm). Depending on surrounding conditions, this distance may be less.
Maximum power consumption: Approximately 4.1W (while charging)
Operating environment: Temperature, 41˚F – 95˚F (5˚C – 35˚C) / humidity, 20-80 percent
Dimensions: Height: 93 mm / width: 156 mm / thickness: 22 mm (when closed)
Weight: Approximately 336 g (including battery pack (SPR-003), stylus (SPR-004), and SD Card)
Charge time: Approx. 3 hours and 30 minutes
Battery endurance: Please see page 17.
77