Charging The Battery Pack - Nintendo 3DS XL Manual Del Operador

Battery cover
Remove cover to replace the battery.
NOTE: Do not remove the cover unless you
need to replace the battery or check battery
installation.
Infrared transceiver
Sends and receives information when
using infrared communication.
L Button
Outer cameras
Used by games or other applications that
include camera features. Two cameras allow
you to take 3D photographs.
NOTE: Avoid getting the camera lenses
dirty. If they become dirty, wipe gently with
a soft cloth, being careful not to damage
the lenses.
Camera LED
Lights up when the outer
cameras are in use.
Game Card slot
For loading Nintendo 3DS Game Cards. Also compatible
with Nintendo DS and Nintendo DSi Game Cards.
12
SD Card slot
For inserting an SD or SDHC Card (see page 20).
Wrist strap attachment
For attachment of a licensed wrist strap (sold
separately).
Stylus holder
Always replace the stylus into
the stylus holder after use.
NOTE: To prevent damage to
R Button
the Nintendo 3DS XL system, do
not insert anything other than a
Nintendo 3DS XL licensed stylus
into the stylus holder.
AC adapter connector
Allows connection of the Nintendo 3DS AC adapter
(included), for recharging the battery or operation using
household current (see page 13).
Cradle connectors
Allows connection to the Nintendo 3DS XL charging
cradle (sold separately, see page 2).

Charging the Battery Pack

Do not use the Nintendo 3DS AC adapter or charging cradle during a lightning storm.
WARNING
There may be a risk of electric shock from lightning.
IMPORTANT: The Nintendo 3DS AC adapter, Model No. WAP-002(USA), is for use only with the Nintendo 3DS family of
systems and the Nintendo DSi and Nintendo DSi XL systems (for more information see page 78). It is not compat-
ible with any other Nintendo system. Do not use the AC adapter with voltage transformers, dimmer switches, or any
other equipment. It is only for use in a standard 120-volt AC wall outlet.
Logo faces up
1 Insert the DC plug from the AC adapter into the AC adapter connector on the back of the Nintendo 3DS XL. Be sure to
insert it straight into the connector.
IMPORTANT: Be sure the DC connector plug is facing in the correct direction before inserting into the
connector to avoid damaging either the plug or connector.
Swing the prongs out of the AC adapter and insert into a standard 120-volt AC wall outlet
2
light, indicating the system is charging. When fully charged, the recharge LED will go out. When charging is complete,
remove the AC adapter from the wall outlet and fold the prongs back into the housing.
IMPORTANT: The AC adapter should be correctly oriented in a vertical or floor-mounted position. The cord
should always face downward.
NOTE: If you play a game while recharging, the recharge LED may not always turn off once charging has completed.
• Battery recharge time is approximately 3 1/2 hours, depending on remaining charge when you start and whether or not you
are using your system during recharging.
• Optimal charging temperature is between 40º and 95º Fahrenheit (5-35º Celsius). Temperatures above or below this may
decrease the life of the battery and adversely affect the ability of the battery to charge.
• The battery pack can be recharged approximately 500 times, after which battery life may be 70% of a new battery.
• Battery packs become worn with repeated charge/discharge cycles. If usage time gets very short, replace the battery pack
(see page 64).
Swing prongs out
Recharge LED will
light up
. The recharge LED will
13