Fixing The Dx10-R To A Powerholder And Pole - Leica DX10 Manual De Uso

1.5
Components of the
PowerHolder
Fixing the DX10-R
and PowerHolder
to a pole step-by-
step
10

Fixing the DX10-R to a PowerHolder and Pole

The PowerHolder consists of a number of components, as shown in the
diagram.
a
b
c
DX10_08
GHT52 clamp
a) Plastic sleeve
b) Pole clamp
c) Clamp bolt
PowerHolder
d) Tightening screw
e) Mounting arm
f) LED
g) Mounting plate
h) Safety screw
i) Cable to connect DX10 (9 PIN SubD connector)
j) Battery compartment
k) Locking mechanism for battery
l) Space for clip-on-housing with LEMO port
Description
1. Remove holder from the travel container.
2. A plastic sleeve may be required to be fitted to the pole clamp.
3. Insert pole into the clamp hole.
4. Adjust the angle of the mounting plate and the height of the holder
on the pole to comfort.
5. Tighten the clamp with the tightening screw.
Once tightened, the button on the tightening screw can
be depressed to change the position of the handle for
more comfort.
A locking mechanism is incorporated in the mounting
plate of the holder.
DX10
l k j i
Description of the System
d
e
f
g
h