Caution! – If the "Sun ON" (or "Sun OFF") symbol is on the display, when the command is sent to the automation system, it will also send this setting (read the description of
the special "Sensor ON/OFF" function in Section 1 of the manual). Alternatively, first cancel the "Sun ON" (or "Sun OFF") setting using Procedure G in Section 9.
E.2
Sending a manual command when the automatic mode on the transmitter is deactivated ("Man")
In this mode, the user can send a command to any group or set of groups, as follows.
01. Call up the term "Man" on the display (= automatic mode deactivated).
02. Press "sel" repeatedly sending the (flashing) cursor through the various groups (note – after group 6, if you wish to return to group 1, press "sel" another 3 times); then
stop the cursor next to the group you wish to select. • Confirm the selection with "ok": (the cursor will stop flashing).
03. If you wish to form a "multiple group", repeat step 02 for each group you wish to add to the "multiple group".
04. Now send the command to the selected multiple group with key ▲, n or ▼.
Step 1
main
screen
stop/esc
Auto
several times ...
(display)
... Step 3
example:
ok
1
2
3
4
5
6
confirm
(permanently ON)
Caution! – If the "Sun ON" (or "Sun OFF") symbol is on the display, when the command is sent to the automation system, it will also send this setting (read the description of
the special "Sensor ON/OFF" function in Section 1 of the manual). Alternatively, first cancel the "Sun ON" (or "Sun OFF") setting using Procedure G in Section 9.
F
To send another manual command to a previously selected group
The transmitter stores the last group (or multiple group) in memory selected by the user in memory
to the group in question with the ▲, n or ▼ keys without having to select it first.
Caution! – If the "Sun ON" (or "Sun OFF") symbol is on the display, when the command is sent to the automation system, it will also send this setting (read the description of
the special "Sensor ON/OFF" function in Section 1 of the manual). Alternatively, first cancel the "Sun ON" (or "Sun OFF") setting using Procedure G in Section 9.
Step 2
Auto
sel
Man
Prog
1 time
(display)
Step 4 (optional)
If you wish to form a "multiple group",
repeat step 03 for each group you wish
to add to the "multiple group".
ok
Man
(permanently ON)
confirm
(display)
Passo 5 - end
sending the command
(See procedure E.2)
Step 3 ...
sel
... to select a
desired Group
several times ...
. You can therefore send other manual commands
example:
1
2
3
4
5
6
English – 18