Nice ERA TIME Instrucciones Y Advertencias De Instalación Y Uso página 5

PROCEDURE 2 - Memorizing the ERA TIME as "First Transmitter"
Run the following procedure only if no transmitters have yet been memorized; otherwise use Procedure 3.
Step 1 Step 2
stop/esc
on
power up the motor several times...
... Step 4
example:
ok
1 2 3
4 5 6
confirm (permanently ON)
PROCEDURE 3 - Memorizing the ERA TIME as "Second (third, fourth...) Transmitter"
Run the following procedure only if one or more transmitters are already memorized in the automation. If no transmitter has yet been memorized, you MUST
use Procedure 2.
Step 1 - 2 - 3 - 4

On a new
ERA TIME, not yet
memorized of Procedure 2
Step 7 - end

On a new
ERA TIME, not yet
stop/esc
memorized
hold down ...
Step 3
main
screen
Auto
(display) 1 time
Step 5 - end
stop/esc
hold down ...
Step 5
Execute step
1 - 2 - 3 - 4
stop/esc
hold down ...
3
3 movements
(1)
Auto
sel ok
Man
Prog
(display) confirm
3
stop/esc
3 movements ... release
10
stop/esc
sec.
wait ... release
NOTE:
(1) - If the motor moves 6 times, the memory is full (max. 30 transmit-
ters) and the new transmitter could not be memorized.
stop/esc
... release
Step 4 ...
Man
sel
(perma-
nently ON)
(display) select the GROUP
NOTE:
(1) - This step requires you to select the group (i.e.
transmission channel) to which the automated
system is to be assigned.

On an old
transmitter, already
memorized
example:
1 2 3
4 5 6
(1)
Step 6
stop/esc
3 times
English – 4