Fagor VTR-25 Manual De Instrucciones página 7

interior.qxd 15/1/04
1B.-.ASSEMBLING THE FAN
1B1.- MODELS: VTR-30 / VTR-30M /
VTR-40 / VTR-40M / VTR-40P /
VTR-40PM
1- Unscrew the nuts on the motor
shaft (anticlockwise) and the
motor casing (clockwise)
respectively.
2- Mount the rear protection grille
on the motor casing and fix it in
place with the fastening nut.
3- Insert the blades on the motor
shaft, fastening them in place
with the blade fixing nut.
Turn the blades manually to ensure
they spin freely. If they do not
turn freely go back to point 2 and
mount them again.
4- Mount the front protection grille
and gently press it until it fits into
the plastic ring.
5- Close the safety clip and tighten
the screw.
1B2.- MODEL: VTR-25 / VTR-25M
1- Unscrew the nut on the motor
casing.
2- Mount the rear protection grille
on the motor support and fix it in
place with the nut.
3- Insert the blades on the motor
shaft. Turn the blades manually
to ensure they spin freely. If they
do not turn freely go back to
point 2 and mount them again.
4- Mount the front protection grille
and gently press it until it fits into
the plastic ring.
5- Close the safety clip and tighten
the screw.
18:36 Página 5
6
4. OPERATING INSTRUCTIONS
• Before using the fan, place it on a
stable, flat surface.
• Press the "0" button to ensure the fan
is in stop position, and plug it in.
• Press button 1, 2 or 3 to choose the
fan speed.
Speeds: 0
VTR-25 VTR-25M Off
VTR-35 VTR-35M Off
VTR-40 VTR-40M Off
VTR-40P VTR-40PM Off
2.- OSCILLATION
The oscillation button is located at the
rear of the fan, on top of the motor.
Press the oscillation button in for the
fan to move from side to side. Pull the
button up to stop the fan moving.
3.- TILT
The fan can be tilted upwards or
downwards manually.
5. MAINTENANCE
Unplug the appliance before cleaning it. If
you wish to dismantle it for cleaning,
follow the assembly instructions in
reverse order.
The blades can be washed in tepid water
with a little mild detergent. They can also
be cleaned with a soft damp cloth.
Clean the motor area with a soft damp
cloth. DO NOT SUBMERGE IT IN
WATER. Do not use solvents or abrasive
products to clean the fan.
Before assembling and using the
appliance, all the parts must be
completely dry.
1 2 3
Low High
Low Medium High
Low Medium High
Low Medium High