Other Features; Steam Ironing; Maintenance And Cleaning - Fagor PLC-809CC Manual De Instrucciones

8. As soon as it goes out, the appliance will be
ready for use.
9. Turn the iron's temperature control (2) in an
anti-clockwise direction until "Min" and the
iron will switch off.
10. Press the LED on/off switch (c) to turn the
appliance off.
11. Unplug the mains cable.
12. When the appliance has totally cooled
down, store it in a safe place.

5. STEAM IRONING

1. Unwind and stretch out the steam tube
and mains cable.
2. Fill the boiler with tap water (refer to the
"Filling the Boiler" section).
3. Plug the appliance into a suitable power
point.
4. The LED on/off switch (b) will light up and
the low steam-level button (i) will flash to
show that the appliance is in pre-heating
mode.
5. The low steam-level button (i) will stop
flashing and will light up when the iron
reaches the desired temperature.
6. The hard water indicator (f) will light up at
the same time.
7. Press the low (i), medium (j) or high (k)
steam-level button to select the level of
steam.
8. Turn the iron's temperature control (2)
in a clockwise direction, select 1 point,
2 points or 3 points depending on the
recommendation made on the garment's
label.
9. The pilot light (3) will turn off when the iron
has reached the desired temperature.
10. The appliance is ready to use.
11. Press the steam button (1) for steam
ironing. When no steam is needed, stop
pressing the aforementioned button.
Note: Steam may sometimes continue to
come out after having released the steam
button.
12. Turn the iron's temperature control (2) in an
anti-clockwise direction until "Min" and the
iron will switch off.
13. Press the LED on/off switch (b) to turn the
appliance off.
14. Unplug the mains cable.
15. When the appliance has totally cooled
down, store it in a safe place.
Warning: If you press the steam button when
the steam generator has not reached the
desired temperature, there will be a beeping
sound.

6. OTHER FEATURES

To avoid burns or accidental falls caused
by the tube, the appliance has some
holders for hooking the cable.
These holders are inserted into their
respective holes as shown in figure 5.
On the other hand, to make ironing more
comfortable, the thermal insulation plate
can be released and placed wherever is
most convenient.
AUTOMATIC SWITCH-OFF SYSTEM
If the steam is not used for more than 15
minutes, the appliance will switch to "Wait"
mode. The LED on/off switch (b) will flash
("Wait" mode). Press the switch once and
the appliance will switch on immediately.

7. MAINTENANCE AND CLEANING

• Unplug the appliance and wait until it
cools down before proceeding to clean it.
• Clean the outside of the boiler with a
soft, slightly-dampened cloth.
• The surface of the shoe (6) must always
be clean. Cotton deposits and other
impurities can attack the iron's shoe.
To clean it, it is enough to rub the cold
surface with a soft, slightly-dampened
cloth. Do not use descaling agents.
• Do not use detergents or abrasive
products to clean the appliance.
• With a view to preventing the shoe from
getting scratched, you should avoid
ironing zips, metal buttons, etc, and,
similarly, you should not place the iron
on metal or rough surfaces.
• After each use, empty the tank and let the
iron cool down before putting it away.
13