Stereo
Headset
DR-210DP
©2011 Sony Corporation
Printed in Thailand
Microphone
Wind screen
4-106-656-31(1)
Operating Instructions
Manual de instrucciones
To microphone jack (pink)
To headphone jack (black)
Microphone arm
English
Stereo headset
Features
Light weight design for long lasting wearing comfort.
Flexible microphone designed to minimize surrounding noise.
Single sided cord.
Supported PC models
IBM PC/AT or compatible computer with a microphone input jack and a sound
output jack, or a computer with a built-in sound card.
It is required that the sound card has a power supply for the microphone.
It is required that the microphone input jack and sound output jack are lined up
together.
This is not compatible with Macintosh computers.
How to use
1
Connect the headphone plug (black) to the headphone jack and connect the
microphone plug (pink) to the microphone jack (see fig. ).
2
Adjust the length of the headband so that the headset fits on your ear.
3
Position the small holes of the microphone in front of your mouth by turning
the microphone arm (see fig. ).
About the wind screen
Use the supplied wind screen on the microphone to reduce wind noise.
Note
Handle with care when attaching the wind screen to the microphone. It may be torn by excessive force.
Cord Slider
Specifications
Cord: Approx. 2.5 m (8 ft.
/
in.) / Plug: Gold-plated stereo mini plug (for headphone
1
4
plug), Gold-plated mini plug (for microphone plug) / Mass: Approx. 58 g (2.05 oz.)
(without cord)
<Receiver>
Type: Open air, dynamic / Driver unit: 30 mm (CCAW Voice Coil), dome type /
Power handling capacity: 1,000 mW (IEC*) / Impedance: 24 Ω at 1 kHz /
Sensitivity: 100 dB/mW / Frequency response: 40 – 20,000 Hz
<Microphone>
Design: Flexible boom microphone / Type: Electret condenser / Open circuit voltage
level: –40 dB (0 dB = 1 V/Pa) / Effective frequency range: 20 – 20,000 Hz
<Supplied accessories>
Wind screen (1)
Operating Instructions (1)
* IEC = International Electrotechnical Commission
Design and specifications are subject to change without notice.
Precautions
Be careful not to use the headset at too loud a volume level. Otherwise, you may have
audio feedback (a howling effect) as the microphone picks up the loud sound from the
headphone unit.
Listening with the headset at high volume may affect your hearing. For traffic safety,
do not use while driving or cycling.
Do not put weight or pressure on the headset as it may cause the headset to deform
during long storage.
The earpads and wind screen may deteriorate due to long term storage or use.
Do not pull the cord slider in the direction of the plugs forcibly. It may cause the wire
to break.
The validity of the CE marking is restricted to only those countries when it is legally
enforced, mainly in the countries EEA (European Economic Area).