Layout - EINHELL Expert TE-XM 305 U Manual De Instrucciones

Anleitung_TE_XM_305_U_SPK8__ 26.09.12 16:31 Seite 43
motor is switched off. - Pull out the power plug!
Before you switch on the machine, check that all
n
wrenches and adjustment tools have been
removed.
When you leave your workplace, switch off the
n
motor and pull out the power plug.
Electric installation work, repairs and
n
maintenance are to be carried out only by
specialists.
All guards and safety devices have to be refitted
n
immediately after completion of any repairs or
maintenance.
It is imperative to observe the manufacturerʼs
n
safety, operating and maintenance instructions
as well as the dimensions quoted in the technical
data.
It is imperative to observe the accident
n
prevention regulations in force in your area as
well as all other generally recognized rules of
safety.
Switch on the dust extraction system each time
n
you use the machine.
The machine may be used in closed rooms only
n
in conjunction with a suitable vacuum extraction
system.
Never use light-duty machines for heavy-duty
n
work.
Never use the cable for any purpose other than
n
that for which it is intended!
Adopt a firm standing position and keep your
n
balance at all times.
Check the tool for signs of damage!
n
Before you carry on using the tool it is imperative
n
to check that its safety devices and any slightly
damaged parts are working properly and in the
way intended.
Check that the moving parts work properly and
n
do not jam or whether any of the parts are
damaged. All parts must be fitted correctly and
satisfy all conditions for the tool to work properly.
Unless otherwise stated in these instructions,
n
damaged safety devices and parts must be
repaired or replaced by experts in an approved
specialist workshop.
Have damaged switches replaced by a customer
n
service workshop.
This tool complies with the pertinent safety
n
regulations. Repairs are to be carried out only by
qualified electricians using original replacement
parts. The user may suffer an accident if this
condition is not observed.
Pull out the power plug and twist the blade with
n
your hand into the 45° and 90° positions in order
to make sure that the blade does not touch the
turntable in any position. If necessary, readjust
the saw head.
If the table insert is worn, replace it.
n
Never use blades made of high-speed steel
n
(HSS).
When cutting miters, make sure that the device
n
for swiveling the arm is fastened securely.
Be careful when working in vertical mode.
n
Caution: Take extra care when making double
n
miter cuts!
Do not overload your tool.
n
Wear safety goggles.
n
Use a dust mask when working on dusty jobs
n
Check the tool cable/extension cable for damage.
n
Always wear gloves when handling saw blades
n
Do not lose these safety instructions.

2. Layout

2.1 Drag, crosscut and miter saw (Fig. 1-3)
1. Handle
2. ON/OFF switch
3. Release lever
4. Machine head
5. Saw shaft lock
6. Movable blade guard
7. Saw blade
8. Vertical clamping device
9. Roll base with limit stop
10. Holding bar for the roll base
11. Stop rail
12. Table insert with cutting depth scale
13. Latched position lever
14. Locking grip
15. Pointer
16. Scale
17. Turntable
18. Fixed saw table
19. Scale
20. Pointer
21. Horizontal clamping device
22. Locking screw
23. Chip box
24. Drag guide
25. Locking screw for drag guide
26. Guard
27. Fastening bolt
28. Locking screw for the horizontal clamping device
29. Locking screw for the vertical clamping device
30. Locking screw for the roll base
31. Foot with rubber stopper
32. Foot
GB
43