Maintenance And Service; Safe Operation - EINHELL Expert TE-XM 305 U Manual De Instrucciones

Anleitung_TE_XM_305_U_SPK8__ 26.09.12 16:31 Seite 41
perform its intended function. Check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other
conditions that may affect its operation. A guard
or other part that is damaged should be properly
repaired or replaced by an authorized service
center unless otherwise indicated elsewhere in
this instructions manual. Have defective switches
replaced by an authorized service center. Do not
use tool if switch does not turn it on and off.
20. Warning
– The use of any other accessory or attachment
other than recommended it this operating
instruction or the Einhell catalog may present a
risk of personal injury.
21. Have your tool repared by an expert
– This electric appliance is in accordance with the
relevant safety rules repairing of electric
appliances may be carried out only by experts
otherwise it may cause considerable danger for
the user.
22. Connect the dust extraction device
Wherever there are facilities for fitting a dust
extraction system, make sure it is connected and
used.
Special safety instructions
1. Safety actions
Blades that are deformed or cracked must not be
used.
If the table insert is worn, replace it.
Use only blades which are recommended by the
manufacturer and comply with EN 847-1.
Make sure that the chosen blade is suitable for
the material that is to be cut.
If necessary, wear suitable personal protection
equipment. This could consist of:
- Ear plugs to prevent the risk of damaging your
hearing;
- A breathing mask to avoid the risk of inhaling
hazardous dust.
- Always wear gloves when handling saw blades
and rough materials. Whenever practicable, saw
blades must be carried in a container.
The following can have an influence on dust
development:
- Worn, damaged or cracked saw blades
- Recommended capacity of the vacuum
extraction system: 20 m/s
- Proper guidance of the workpiece
Blades made of high-alloy high-speed steel
(HSS) must not be used.
Keep the push stick or handle for a push block at
the machine at all times, even when you are not
using them.

2. Maintenance and service

The following conditions can have an influence
on noise impact on the operator:
- Type of sawblade (e.g. saw blades designed to
reduce noise development)
- Material of the workpiece
- The force with which the workpiece is pushed
against the sawblade
Faults on the machine or its guards, safety
devices and blade must be reported to the
person in charge as soon as they are
discovered.

3. Safe operation

Select a suitable blade for the material you wish
n
to saw.
Never use the drag, crosscut and miter saw to cut
n
any materials other than those specified by the
manufacturer.
Use only the transport devices to move the
n
machine. Never use the guards for handling or
moving the machine.
Use the saw only if it is in perfect condition and
n
properly maintained.
When cutting miters, make sure that the device
n
for swiveling the arm is fastened securely.
The floor around the machine must be level,
n
clean and free of loose particles, such as chips
and cutting residues.
Make sure the workplace and the room are
n
sufficiently illuminated.
The operator must receive proper training in the
n
use, adjustment and operation of the machine.
Only use properly sharpened saw blades. Do not
n
exceed the maximum speed specified on the
blade.
Be sure to only use spacers and spindle rings
n
specified by the manufacturer as suitable for the
intended purpose.
If the machine is equipped with a laser, this laser
n
may not be replaced by a different type of laser.
Repairs may only be carried out by the
manufacturer of the laser or one of his authorized
agents.
GB
41