Technical Data; Before Starting The Equipment; General Information - EINHELL Expert TE-XM 305 U Manual De Instrucciones

Anleitung_TE_XM_305_U_SPK8__ 26.09.12 16:31 Seite 45
used in closed rooms.
Cut injuries through contact with chips and
n
workpieces.
Eye injuries caused by small metal chips.
n

5. Technical data

AC motor:
Power:
Operating mode:
Idle speed n :
0
Carbide saw blade:
Number of teeth:
Swiveling range:
Miter cut:
Saw width at 90°:
Wood:
Metal:
Saw width at 45°:
Wood:
Metal:
Saw width at 2 x 45° (double miter cut):
Wood:
Metal:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 13898.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
pA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
"The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions.
Factors with a potential influence on the actual
immission level at the workplace include the duration
of impact, the type of room, and other sources of
noise etc., e.g. the number of machines and other
neighboring operations. Reliable workplace values
may also vary from country to country. With this
information the user should at least be able to make a
better assessment of the dangers and risks involved."
Total vibration values (vector sum of three directions)
determined in accordance with EN 13898.
230V ~ 50Hz
Vibration emission value a
1800 W
Reduce noise generation and vibration to a
S1
minimum!
2,500 min -1
n
ø 250 x ø 30 x 2.2 mm
n
n
48
n
-52° / 0°/ +60°
n
0° to 45° to the left
n
Residual risks
305 x 75 mm
Even if you use this electric power tool in
105 x 75 mm accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
210 x 75 mm
construction and layout:
1. Lung damage if no suitable protective dust mask
70 x 75 mm
2. Damage to hearing if no suitable ear protection is
210 x 40 mm
3. Health damage caused by hand-arm vibrations if
70 x 40 mm
approx. 17.5 kg

6. Before starting the equipment

6.1 General information

93.7 dB(A)
n
2 dB
108.5 dB(A)
n
2 dB
n
n
n
n
= 1.068 m/s
h
Use only equipment that is in perfect condition.
Maintain and clean the equipment regularly.
Adapt your working methods to the equipment.
Do not overload the equipment.
Have the equipment checked if necessary.
Switch off the equipment when not in use.
is used.
used.
the equipment is used over a prolonged period or
is not properly guided and maintained.
Before commissioning the machine, it must be
firmly mounted on a workbench; fully assemble
the underframe that came with the unit or similar.
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws, etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Check that the voltage on the rating plate is the
same as your supply voltage before you connect
the machine to the power supply.
GB
2
45