F Ir S T U S E - Nescafe Dolce Gusto Genio 2 Manual De Usuario

5 .
1
E N
Rinse water tank manually with fresh drinking
water. Fill water tank with fresh drinking water.
Insert water tank into machine.
4
Switch on machine. Power button starts
blinking red while machine is heating up for
approximately 40 seconds. Afterwards power
button lights steady green. Machine is ready
to use.
7
Push selection lever to the "HOT" position.
Machine starts rinsing.
This is an electronic document, It's only controlled if it's opened directly from the source-RQM
F I R S T U S E
2
Open locking handle. Make sure that rinsing
tool is in capsule holder and capsule holder
is in machine. Close locking handle. Place an
empty large container underneath the coffee
outlet.
5
Set bar display to maximum level with selec-
tion lever. Push selection lever to the "COLD"
position. Machine starts rinsing. Lights on bar
display vanish progressively.
8
STOP
Wait until the lever moves to the "STOP" posi-
tion. Open locking handle. Pull out capsule
holder. Remove rinsing tool. Reinsert capsule
holder.
3
Ensure to use the correct mains voltage as given
in "2. MACHINE OVERVIEW". Connect power
plug to mains power socket.
6
Wait until the lever moves to the "STOP" posi-
tion. Extraction stops. Power button blinks red
for about 5 seconds.
9
Empty container. Fill water tank with fresh
drinking water. Insert water tank into machine.
Place drip grid on drip tray. Then insert drip
tray at desired position.
8