Bosch GHO 26-82 Instrucciones De Servicio página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EURO • BA 2 609 140 180 • GHO 26-82 • GB • OSW 02/04
2 609 140 180.book Seite 3 Mittwoch, 3. April 2002 9:19 09
Planing (see figure
B
Set the required planing depth and place the front
part of the planer shoe 11 against the workpiece.
Caution! Danger of kickback!
Apply the machine to the workpiece
only when switched on.
Switch the machine on and guide the machine
with an even feed over the surface to be planed.
To achieve high-grade surfaces, work only with
low feed and apply pressure on the centre of the
planer shoe.
When machining hard materials (e. g. hardwood)
as well as when utilising the maximum planer
width, set only low planing depths and reduce
planer feed, as required. Repeat the planing sev-
eral times.
Excessive feed reduces the surface quality and
can lead to rapid clogging of the chip ejector.
Only sharp blades achieve good cutting capacity
and give the machine longer life.
Continuing interrupted planing
The integrated blade protector 21 also allows for
continued planing at any given location on the
workpiece after an interruption:
– With the blade protector folded down, place
the machine on the location of the workpiece
where the planing is to be continued.
– Switch the machine on.
– Apply the supporting pressure onto the front
part of the planer shoe and slowly push the
machine forwards ( ). This tilts the blade pro-
tector 21 up ( ) so that the rear part of the
planer shoe 11 faces on the workpiece again.
– Guide the machine alongside the surface to be
planed ( ) with an even feed.
13 • 2 609 140 180 • TMS • 08.03.02
)
Beveling Edges
The V-grooves 12 in the front planer shoe 11 al-
low quick and easy beveling of workpiece edges.
Depending on required bevel width, use the cor-
responding V-groove.
For this, place the planer with the V-groove 12
onto the edge of the workpiece and guide along
the edge.
Using the Parallel/Angle Guide
(Accessory)
Mount parallel guide 13 or angle guide 17 to the
machine using fastening bolt 14 and rebating
depth stop 2 using fastening bolt 1.
Loosen locking nut 15 and adjust the required re-
bating width with the scale 16. Retighten locking
nut 15 again.
Adjust the required rebating depth accordingly
with the rebating depth stop 2.
Carry out the planing procedure several times,
until the required rebating depth is reached. Pay
attention that the planer is guided with sideward
supporting pressure.
Beveling (only angle guide 17)
When beveling rebates and surfaces, adjust the
required slope angle with the angle adjust-
ment 18.
English - 3
9 mm
max
12
45°

Publicidad

Tabla de contenido
loading

Tabla de contenido