Troubleshooting; Product Registration Card - WAGNER PAINTMATE PLUS Manual Del Propietário

TROUBLESHOOTING

PROBLEM
There is paint leakage on the
roller arm assembly
Plunger is difficult to pull/push
The fill tube will not fill with paint
or paint leaks from fill valve
* Replacement parts available by calling customer service
Have you tried the recommendations above and are still having problems? In the United States, to speak to a
customer service representative, call our Customer Service at 1-763-519-3555 Monday through Friday between 8:00
AM and 4:30 PM Central time. An automated Self-Help option is also available at 1-800-328-8251, seven days a week,
twenty-four hours a day.

PRODUCT REGISTRATION CARD

Send in your product registration card or register online at www.wagnerspraytech.com. Proper registration will serve as proof of
purchase in the event your original receipt becomes misplaced or lost. Returning this card will expedite the processing of your
warranty. Be sure you write your unit's date code on the card before sending it. The date code is located on the Power Trigger
your unit (for example, T087A). The additional information will also help us to develop new products that best meet your needs and
desires. If you have any questions or concerns regarding your registration card, please call our registration card center at 1-303-394-
9077.
© 2001 Wagner Spray Tech. All rights reserved.
CAUSE
The seal on the arm is backwards
The seal and cap were not properly cleaned
The O-ring and the connecting area were not
cleaned properly
Paint residue on connecting areas
The O-rings are damaged or missing
The roller cover is worn or damaged
The core or cap is worn or damaged
The bearing areas are worn
O-rings are not lubricated
Paint residue on fill valve components
Locking cap
Retaining disk
Duckbill valve
Valve housing
Connecting
area
5
SOLUTION
Turn the seal around
Clean and properly lubricate
Clean and properly lubricate
Clean connecting areas
Replace the O-rings*
Replace the roller cover*
Replace the core or cap*
Call Customer Service
Lubricate the O-rings on the plunger
A) Insert fill tube firmly into fill valve and
twist fill tube several times to break up
paint residue
B) If the problem persists, refer to the
steps below to clean the fill valve
components
1. Unscrew the locking cap on the valve housing by turning it
counterclockwise.
2. Remove the retaining disk and the duckbill from the valve
housing.
3. Clean these parts thoroughly using the appropriate cleaning
solution.
4. Replace the duckbill valve and retainer disk.
5. Screw the locking cap on the valve housing by turning it
clockwise.
®
of
English
The Painting People ™