Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
A.
The pump will not run
B.
Paint fails to load the roller.
C.
The motor does not turn off.
D.
There is paint leakage.
E.
Water leakage from the
Quick-clean™ inlet fitting
during cleaning.
* Replacement parts available by calling customer service
Have you tried the recommendations above and are still having problems? In the United States, to speak to a
customer service representative, call our Customer Service at 1-800-328-8251 Monday through Friday between 8:00
AM and 4:30 PM Central time.
Product Registration
Register your product online at www.wagnerspraytech.com. Proper registration will serve as proof of purchase in the event your
original receipt becomes misplaced or lost.
All manuals and user guides at all-guides.com
Troubleshooting
Cause
1.
The power cord is unplugged, or no power
in outlet.
2.
The variable speed dial is turned to 0
(OFF) and handle button has not been
pressed.
3.
There is a kink in the air hose.
1.
The suction tube is not immersed in the
paint.
2.
There is an obstruction in the suction tube.
3.
The paint can is empty.
4.
The O-rings on the Quick-clean™ inlet
plug are worn or dirty.
5.
The Quick-clean™ plug is missing from the
Quick-clean™ adapter.
1.
The handle button is activated.
2.
There is a kink in the air hose.
3.
There is an air switch malfunction.
1.
The seal on the roller arm is backwards.
2.
The seal and cap were not properly
cleaned.
3.
The O-ring and the connecting area were
not cleaned properly.
4.
Paint residue on connecting areas.
5.
The O-rings are damaged or missing.
6.
The roller cover is worn or damaged.
7.
The roller core or cap is worn or damaged.
8.
The bearing areas on the roller arm are
worn.
9.
The pump tube is punctured.
10.
The paint hose is damaged.
11.
The O-rings on the Quick-clean™ inlet
plug are worn or dirty.
12.
The Quick-clean™ plug is missing from the
Quick-clean™ adapter.
1.
Missing washer.
Solution
1.
Plug the power cord into 120V outlet
2.
Turn variable speed dial to higher setting (1-9) and
press handle button.
3.
Unkink the air hose
If unit still fails to run, call Customer Service.
1.
Fully immerse the tube into the paint.
2.
Remove the obstruction.
3.
Fill the paint can.
4.
Properly clean and lubricate, or replace.
5.
Install Quick-clean™ plug.
1.
Press and release handle button.
2.
Unkink the air hose.
3.
Unplug unit, then call Customer Service.
1.
Turn the seal around.
2.
Clean and properly lubricate.
3.
Clean and properly lubricate (pg 12).
4.
Clean connecting areas.
5.
Replace the O-rings*
6.
Replace the roller cover*.
7.
Replace the roller core or cap*.
8.
Call Customer Service
9.
Call Customer Service
10.
Call Customer Service
11.
Properly clean and lubricate, or replace.
12.
Install Quick-clean™ plug.
1.
Replace.
13
English
Publicidad
Tabla de contenido
Solución de problemas
