Clatronic BS 1239 Instrucciones De Servicio página 49

5....-05-CB 959 Bodensauger
3. Remove the central filter (see illustration 4). Empty the chamber of the filter
and then clean the filter.
4. Reinsert the central filter and then close the filter flap of the dust container.
Important: Always empty the dust container first before you remove the
central filter.
5. Reinsert the dust container and then close the lid of the filter housing.
Every third time that the device is emptied, or in the case of major soiling, please
also clean the filters located in the flap (A 5) of the dust container. This flap (see
illustration 5) consists of two halves which can be separated. Open these two hal-
ves and clean the filters by allowing running water to pass through the filter fleece
in the direction contrary to which the air blows through the device.
These filters should only be replaced when they are completely dry. Then remount
the flap.
2. Motor Protective Filter (A1)
The motor protection filter is located vertically in the rear section of the filter hou-
sing. Remove the protective grating together with the filter by pulling them upwards.
Then remove the filter. Clean the filter approximately every 10th time the dust con-
tainer is emptied. If necessary the filter can be cleaned in warm water without any
additives. This should only be replaced when it is completely dry!
3. Outlet filter (HEPA Filter):
In addition, your device has an outlet filter. This filter is to be found on the rear sec-
tion of your device behind a protective grating. Open the protective grating by pres-
sing the button on the top of the grating (see illustration 6). Then remove the gra-
ting. Take out the filter and replace it with a new one.
In order to guarantee the smooth functioning of the filter we recommend that it be
replaced every six months.
As an alternative to the transparent dust collection container, the device can also
be operated with dust bags.
Replacing the dust bag:
• Switch the device off and remove the mains plug from the socket.
• Open the lid of the filter housing and remove the bag holder.
• Pull the dust bag out of the holder.
• Insert a new bag and then place the bag holder back in position. Close the lid
such that it locks in place.
10.08.2004
Operation with Dust Bags
9:02 Uhr Seite 49
49
GB