Overview Of The Components; Using The Appliance - Clatronic BS 1239 Instrucciones De Servicio

5....-05-CB 959 Bodensauger
1 Hose connection
2 Filter housing handle
3 Filter housing lid
4 Suction hose button
5 Cable take-up button
6 Filling level indicator
7 Hose
8 Suction power regulator
A1 Motor protection filter
A2 Dust bag holder
A3 Dust container
A4 Button for emptying the dust
container
A5 Filter flap
A6 Central filter
1. Insert the vacuum hose in the opening in the dust bag compartment until it
locks in mechanically.
2. To release the hose, press the button on the vacuum hose.
3. Keep the button pressed and pull out the hose.
4. Insert the vacuum tube into the handle if required.
1. Fit on the accessory.
2. Unwind the necessary length of cable and insert the plug in a duly installed
230V/50Hz protective contact socket.
3. Set the vacuum power with the vacuum power regulator.
4. Vacuum at a steady speed. There is no need to exert pressure.
5. Attention: pay attention to the range that can be covered with the cable length.
Vacuum power regulator
Low vacuum power:
Medium vacuum power:
High vacuum power:
Cable winding device:
Pull out the cable up to the maximum length indicated with the yellow mark. Never
pull the cable out up to the red mark as the cable winding can be damaged. Said
damages are not covered by the warranty.
10.08.2004

Overview of the Components

Start-up

Using the Appliance

For curtains and delicate fabrics
For long-pile velour carpets and textile flooring
For sturdy rugs and floors
9:02 Uhr
9 Handle
10 Air slide
11 Suction tube
12 Carrying handle
13 On/off switch
14 Parking assistance
15 Floor nozzle changeover switch
16 Floor nozzle
B1 Accessories compartment
B2 Upholstery nozzle
B3 2-in-1 crevice/brush nozzle
C1 Protective grating button
C2 Mains power line
Seite 47
GB
47