Poulan Pro PP445 Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Never use waste
oil for bar and chain
lubdcation.
• Always
stop the engine
before removing
the oil cap.
IMPORTANT
Experience
indicates
that alcohol
blended
fuels
(called
gasohol
or using ethanol
or
methanol) can attract moisture which leads to
separation and formation of acids during stor-
age. Acidic gas can damage the fuel system
of an engine while in storage.
To avoid engine
problems, empty the fuel system before stor-
age for 30 days or longer. Drain the gas tank,
start the engine and let it run until the fuel lines
and carburetor
are empty. Use fresh fuel next
season.
Never
use engine
or carburetor
cleaner products in the fuel tank or permanent
damage may occur.
See the STORAGE
section for additional
in-
formation.
HOW TO STOP YOUR
UNIT
• To stop the engine,
move the ON/OFF
switch to the OFF position.
• If engine does not stop, move choke lever
to the FULL CHOKE position.
F Switch
HOW TO START
YOUR
UNIT
_, WARNING:
Make sure the chain will
not make contact with any object while start-
ing the engine. Never try to start the unit when
the guide bar is in a cut.
Avoid any contact
with the muffler. A hot muffler can cause seri-
ous burns.
STARTING
A COLD
ENGINE
(or a
warm
engine
after
running
out of
fuel)
Choke
.Lever
Muffler
1.
Set unit on a flat surface.
2.
Move ON/OFF switch to the ON position.
3.
Slowly press the primer bulb 6 times.
4.
Move choke lever to FULL CHOKE by
aligning lever with position shown on de-
cal (see illustration
below).
Choke
position
decal
5.
Squeeze the throttle trigger fully and hold
through all remainin 9 steps.
6.
Pull starter rope handle sharply until en-
gine sounds as if it is trying to start, but do
not pull rope more than 6 times.
7.
As soon as engine sounds as if it is trying
to start,
move
choke
lever to HALF
CHOKE
by aligning
lever with position
shown on decal (see illustration
below).
Choke
position
10
8.
Pull starter rope sharply until engine runs,
b_ no more than 6 pulls. If the engine
doesn't start after 6 pulls (at the HALF
CHOKE position), move the choke lever to
the FULL CHOKE position and press the
primer bulb 6 times. Squeeze and hold the
throttle trigger and pull the starter rope 2
more times. Move the choke lever to the
HALF CHOKE position and pull the starter
rope until the engine runs, but no more than
6 pulls. If the engine doesn't start, repeat
procedure 2 additional times.
NOTE:
if engine still doesn't start, it is
probably flooded. Proceed to STARTING A
FLOODED ENGINE.
9.
Once the engine starts, allow it to run 10 se-
conds, then move the choke lever to OFF
CHOKE
by aligning
lever with position
shown on decal (see illustration below). Al-
low the unit to run for 30 more seconds at
OFF CHOKE before releasing the throttle
trigger. NOTE:
If engine dies with the
choke lever in the OFF CHOKE position,
move the choke lever to the HALF CHOKE
position and pull the rope until engine runs,
bL_ no more than 6 pulis.

Publicidad

Tabla de contenido
loading

Tabla de contenido