Poulan Pro PP445 Manual De Instrucciones página 16

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
TABLE
WARNING:
Always stop unit and disconnect spark plug before performing
all of the
recommended
remedies below except remedies that require operation
of the unit.
TROUBLE
Engine will not
start.
CAUSE
REMEDY
1. MoveON/OFF switch to ON.
1. ON/OFF switch in
OFF position.
2. Engine flooded.
3. Fuel tank empty.
4. Spark plug not firing.
5. Fuel not reaching
carburetor,
6. Carburetor
requires
adjustment.
Engine will
1. Idle speed set too high
not idle
or too low.
properly.
2. Crankshaft
seals worn.
3. Compression
low.
1. Air filter dirty.
2. Spark plug fouled.
Engine will not
accelerate,
lacks power,
or dies under
a load.
3. Carburetor
requires
adjustment.
4. Carbon build-up on
muffler outlet screen.
5. Compression
low.
1. Choke partially on.
2. Fuel mixture incorrect.
2. See "Starting
a Flooded Engine" in
Operation Section.
3. Fill tank with correct fuel mixture.
4. install new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
6. Contact an authorized
service dealer.
1. See "Carburetor Adjustment"
in
Service and Adjustments
Section.
2. Contact an authorized
service dealer.
3. Contact an authorized
service dealer.
1. Clean or replace air filter.
2. Clean or replace plug
and regap.
3. Contact an authorized
service dealer.
4. Contact an authorized
service dealer.
5. Contact an authorized
service dealer.
Engine
1. Adjust choke.
smokes
2. Empty fuel tank and refill with
_=xcessively.
correct fuel mixture.
3. Air filter dirty.
3. Clean or replace air filter.
4. Carburetor
requires
4. Contact an authorized
service dealer.
adjustment.
Engine runs
1. Fuel mixture incorrect.
1. See "Fueling Engine" in Operation
hot.
section.
2. Spark plug incorrect.
2. Replace with correct spark plug.
3. Carburetor
requires
3. Contact an authorized
service dealer.
adjustment.
4. Carbon build-up on
4. Contact an authorized
service dealer.
muffler outlet screen.
Chain moves at
1. Idle speed requires
1. See "Carburetor Adjustment"
in
idle speed,
adjustment.
Service and Adjustments
Section.
2. Clutch requires repair.
2. Contact an authorized service dealer.
16

Publicidad

Tabla de contenido
loading

Tabla de contenido